Hi,
Please share a good doc of Riverbed WAN OPT techniques.
What is it?
Why we use it.
Advantages
CLI & GUI modes
Commands
Would be grateful if anyone can explain
I have had a number of these routers show inconsistent negotiation:
Either negotiate to 100FULL, or not negotiate at all "notconnect" - thus affecting WAN access
I have noticed something unusual - the interfaces are seen as Gigabit even though they a...
Hi Friend,
Motive: To generate looping scenario in bgp, for implementing soo community.
I am trying to create loop under bgp ,CE1 & CE2 running under AS 100 , PE1/PE2 running on AS200.
Topology
CE1----PE1----PE2---CE2 | ...
Hi,
I am trying to get the following values for a cisco 3G/4G router using snmpGet or snmpWalk and MIB ciscoWan3gMIB. The values below can be retrieved using show cellular command. I am trying to automate using snmp to report these values instead...
I am getting this error while I apply
class-map match-all rate-limit match input-interface FastEthernet0/4!!policy-map 3M class rate-limit police 3000000 8000 exceed-action drop!
DR-EdgeRouter(config-if)#service-policy output 3MMatch input interfac...
Hi All
Bit of an odd one. I have a requirement to create a site to site IPSEC VPN. Our internal LAN range is 10.0.0.0/24. We are connecting to a network that has an internal range of 15.0.0.0/8. We are using a Meraki on our side going to a Cisco VPN...
I try to filter default route by command like that default-information {in | out} {access-list-number | access-list-name} I build a default route and redistribute static route in order that default route can be learnt by other eigrp routers. Then...
Hi,
We have been getting the alerts regarding the sla.....
This is ASR1001 router to connect to other router in the other site for p2p circuit.
There is the secondary router for the same purpose but that router doesn't get any error when the primar...
I have a pair of Nexus 7000s running ospf version 2. I want to change the area of one of the networks from area 0 to area 1. The network shows as a network in area 0 under the ospf {instance} section of the configuration. The confusing part is that t...
Hi,
I have 2 SSID on a router and would like them to ping to each other. So I would like to be able to have 2 devices connected one on each SSID and ping to them. How would I do this?
thank you
I have tried creating a vpn tunnel with my 2901 and can not get it to recognize the command crypto isakmp, I have tried IOS
c2900-universalk9-mz.SPA.154-3.M3 and c2900-universalk9_npe-mz.SPA.155-3.M6.bin. i have also activated the security lic, i t...
We had a Cisco 4331 fail and i need to get a site backup asap. I have a 2901 router in stock i was hoping to setup to get the customer by until we replace the 4331. What IOS do i need on the 2901 to have IPSEC capabilities to create a L2L tunnel? ...
