Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Labels

Forum Posts

Why don't Nexus7700's support keepalives for GRE Tunnel interfaces? Conversaion IOS to Nexus Tool = !Nexus Unsupported: Command  keepalive 2 3 is not supported in selected Nexus device I need to build some GRE Tunnels between 7700 Switches and some 3...

Hello,I have a RV042 Router with Dual WAN and I currently have it set up for load balancing. This is working perfectly with the exception that when we login or try to function on some secure websites the websites we are on will recognize that our ext...

Dear Team, I have two link between my head office to branch office and ospf running for routing. I wan to create a virtual link between them and both two link will work as a single link . So how will configure for this ?

Hi All, I have got a topology as shown below: R16---IBGP----R18 |                          | EBGP                 EBGP |                          |   R23--IBGP-----R20 Here R20 is learning a route 192.168.0.0/16 which is generated by R16. The rout...

Hello, Just wanted to check if we support dual DMVPN HuB topology. We have 1 internet and 1 MPLS connection in primary DC and backup MPLS link in secondary DC. We are looking to use secondary MPLS DC link as a backup. I am attaching the topology for ...

Good afternoon My ASR 1001x is using release/patch 3.16.4a.S. Last patch available in Cisco site is 3.16.5S. Cisco IOS Checker presents vulnerabilities only fixed in 3.16.6, not available for download. Do you know when 3.16.6 will be released or wh...

For the ISR 4000, where we can UCS E-Series Modules and how ? If we have 5 routers (ISR 4331) in 5 sites, shall every device has own UCS E-Series Modules or only one module at main site ? Thanks in advance.

Resolved! Cisco 2821 3 Wic

Hello, I have a Cisco 2821 with 3 wic, 2 wic adsl and 1 wic eth. I need to configure the two adsl wics in load balancing and failover and in case of all the two adsl don't work, all the traffic must be routed on the eth wic wan. The IOS version is 12...

jangydb98 by Level 1
  • 6407 Views
  • 32 replies
  • 0 Helpful votes

I have a new router and when we connected it the following keeps coming up in the logs.   There is no interface errors or resets.  No issues with duplex or speed mis-match.   Below are the messages, what can I find on why these are coming? Log Buffe...

Hi All, I have a topology and testing all possible routing in it. I am currently stuck in a redistribution scenario explained as below: The Blue side is EIGRP and the Yellow side is OSPF. Both these protocol are running in a single AS.  Now I want ...

Resolved! OSPF

I have two devices with OSPF but the connecovity it is going to the secondary decive and we need it in the primary. Can we do something similar as clear ip bgp * soft for OSPF?

Unanswered Topics