Routing

Hello, I am trying to configure a transparent proxy using WCCPv2 and Squid proxy in our network infrastructure.  I'm trying to figure out how to transparently capture traffic from our three office routers and forward the traffic to the Squid proxy s...

Hi everyone, i have an question about the Cisco 887VA.I have a router cisco 887VA working perfectly. I already have a site to site VPN working with pre shared key and when i try to add another site to site VPN but to authenticate with certificate i h...

Hi, how can I make a single multihomed BGP internet connection to 2 ISP's fail over active/passive? I'm thinking about using weight (want to manage this on my router) to have traffic go out one prefferred ISP but that's not really Active/Passive. Som...

Hello,we are running the following scenario - to provide QoS (shaping/queueing) for our broadband (pppoe) users, we have configured several service-policies on our 7206/7204 BRAS-Routers. The service-policies are applied with RADIUS-Attributes when t...

Hi, I am not able to turn on workstation using wake-on-lan utility in case when magic packet is sent from different vlan. But same workstation gets turned on if magic packet is sent from same vlan. I am using open source utility -  'mc-wol.exe'. For...

Hi just a generic question  L2TPv3 is it statefull or stateless - from an IOS router perspective like IR829 ? thx and regards ms

Hi Experts, I currently have a WS-C4507R+E at the distribution layer which does static default routing to the WAN Router. The requirement is to run EIGRP on it and have another P2P link terminated on this Switch from a nearby office. This router hen...

Hi, We have an issue where a group of servers are configured across multiple serverfarms,  we are using least connections Algo and we would like to know if the Cisco ACE takes the total number of connections on a per rserver basis,   or is it just pe...

Hello! I have to configure a generic x25 rbp map, how I can do that? I try this: x25 map rbp 0 cud 0x00550055 remote host 10.0.0.1 port 3000 But when I use '0' in DTE source, I have this on debug log: Feb 9 17:17:36.866: Serial0/0/0: X.25 I R1 Call...

Hi all, i am trying to setup two SDSL lines provided from our partner in Belgian on a C888-K9. Here my startup config !controller SHDSL 0 dsl-group auto !! !interface ATM0 no ip address no atm ilmi-keepalive!interface ATM0.1 point-to-point pvc 8/3...

Hi I want to implement QoS for video conferencing over our MPLS links. The video conferencing makes use of Microsoft Lync and Polycom devices. Could anyone provide any sample configurations as to how to go about with the configuration. 

I just got an IR829 router from cisco. I need to install it inside my local network to test a lorawan module. It comes with 15.5 ios version. I have tried to follow some tutorials but I don't get it working. First, I would need a way to remove all t...

I am having an issue, where I had two c3750 stacks configured, connected via Etherchannel, and I was able to connect to both of them via SSH.  We removed most of the switches in the stacks, leaving only the master switch of the first stack and now i ...