Routing

I have a BGP design question for an Enterprise.  I have one edge router handling multipe ISP's for Internet and an additional ISP for MPLS traffic (remote offices) running BGP.  Can I breakout the MPLS onto a separate router using the same registered...

I have an 819 router which I am using message digest for authentication and have Nat configured as well. Everything on the router seems to be working correctly, but I am getting an error in the router log (%OSPF-4-NOVALIDKEY: No valid authentication...

I have a question to understand please clarify me. In the flow chart, which i have attached if the sequence no is higher, go to “A”. when “sequence no” become higher ( increment)?Up to my understanding,1.when there is a change in OSPF network.2.By de...

Dear All, With the attached network diagram, what will be the basic EIGRP configuration to communicate within the two location with unequal cost load balancing. I have configured but not able to communicate within the inside networks. However from O...

I am using Cisco C819G router with 4G for the failover. I have configured an ip sla to verify the primary connection is up. I have configured a track to reroute traffic via the Cellular interface if the primary connection fails. This seems to be work...

What browser is need to access the interface on the 1242 AP. I can get into the GUI, but the apply button does not work.

HI... I run SSH on a DIFFERENT PORT so I can access the router from (INTERNAL NETWORK)  and (REMOTELY INTERNET)......from PC or my ANDROID PROBLEM: when I do a PORT SCAN.......the SSH PORT shows as "OPEN" QUESTION:  How can I SECURE the SSH PORT an...

I know the command to see DDNS actions........ debug ip ddns update I want to be able to see when DDNS updates everytime....can anyone suggest how that can be done I my logs go to a syslog server so i can review them

Hi Team, I'm facing some issues to get the 10gig throughput license activated on an ASR1001-X. I have already ran the command license install ftp://xxxxx:xxxxx@X.X.X.X/license_file.lic, but the show license output still displays Active, Not in Use. A...

Hi, I have 2 links in my router. One is broadband and getting dynamic IP from service provider. Other link is leased line with public IPs. As of now, I was using only broadband link and has default route tpwrd dialer interface. Now, i am plannig to...

Hi, I have two ISPs. I have /24 public IP block from each of ISP. I have NAT configured on my ASA 5525 for WWW service. For example. IP from ISP1: 1.1.1.1 IP from ISP2: 2.2.2.2 When traffic comes in for 1.1.1.1:80, I would like the return traffic g...

Hi guys, which tools or command i could use to check all my traffic in/out from my interface, i have a router with an interface 100 mbits with 10 Sub-interface hanging on it, i would like to measure how many traffic is passing throught it and if i a...