Routing

Hi everybody, We have connectivity between two sites one with a 4/4SHDSL connection, the other has 2x 2048/384 ADSL connections. We are using GRE tunnels and EIGRP to load balance.We are currently being shaped at the proivider edge out to the site ...

Dear Ladies and Gentlemen. We bought a WS-C3560G-48TS-S Switch on the 15th of july 2010.After a power failure the switch never goes online, only the "SYST"-LED lights but no connection or remote access is possible. Do you have any ideas how I can get...

Hi All, I have two nexus 7706 running in my DC which is further subdivided in to two vdc's. And we are running BGP in my WAN layer and OSPF in my CORE layer.  My core layer learns default routing information  from the above two WAN VDC's through OSP...

Hi Experts, If there is congestion from a bidirectional Iperf test using the default fair queue class and I have a loss intolerant application that is bursty (transmits once every 5 minutes, 60 bytes then backs off) set to use the priority queue. Is...

I'll try to explain it better : I'm using  a 877 router to connect to DSL ISP Dialer interface obtains a static ip address after ISP authentication Then all ports and protocols are forwarded to a LAN firewall to make this last figure as it was a pub...

Looking for assistance to get started configuring WAAS on a ISR4351 with built in SM controller. I can not seem to find a interface to setup.  I tried playing with Service Engine interface but not getting anywhere.  Interface              IP-Address...

hi there, I'm trying to block torrents in my network and want to achieve this by next configuration: Cisco_ISR(config)#class-map match-any ALL-P2P-PROTOCOLSCisco_ISR(config)# match protocol bittorrent Cisco_ISR(config)#policy-map P2P- DROP Cisco_IS...

Hello  Experts;                      I am unable to configure  ASR 1001 with voice configurations for SIP . There is no voice commands are showing  under configuration terminal Any help would be higly apreciated KV       

Hello Community, I have a question on BGP advertised routes. I have 2 routers peered together same AS 1 both advertising to the AS of 65000. When issuing the command "IP BGP neighbor x.x.x.x advertised-routes" : Router 1 states: *> 10.20.30.128/27 ...

Hello ,  Any one can explain to me what we mean by ISPF  with ospf .. Actually i read it in them articles but i didn't got it .. it wasn't clear to me .. any one have clear explain .. Thanks in advance 

Are there Valet M20 Router users still asking questions and getting answers from this Cisco Forum or are they having to go to a Belkin Linksys Forum to get their questions answered?