Routing

Hello everybody, just seeting up a new DMVPN HUB, everything works so far but I have got an issue when I try to connect the HUB ssh server through DMVPN tunnel from a location. Only ssh connections over the external (internet side) interface are poss...

Just a quick question. I was implementing the iBGP in core network for redundancy purpose. As I finished the implementing iBGP in all core network device. one of cisco 6509 switch start to having problem and it is not responding properly. I  quickly ...

We have two sites both with Managed MPLS routers.  Then we have a local T1 line between them.   We want to use that local T1 line for backup if the MPLS circuit fails at either site.  I have tested that backup and the route from the failed router nev...

Hi all I have a DVR inside my company its IP address is 192.168.0.50 and port number is 2000 I want outside Internet users to access DVR, How is it possible? Please have a look at the running configuration. DVR is working inside the company but not ...

Hllo all, i have a couple of questions,I have a wan setup, 2 sites connected via a layer 2 point to point at COX.network A can Ping everything on network B.  but that is it,  No rdp to the other servers. no telnet to the routers from A to B (or Vice ...

Hi  I have WS-C4948-10GE ( cat4500-entservicesk9-mz.150-2.SG4.bin ) and I want to limit the internet download bandwidth that reach to subnet xx.107.50.128/25  , interface TenGigabitEthernet1/49 is the interface from ISP side , but with the below con...

I've been experimenting with 6rd tunnels. Using a template I got from somewhere, I configured the following tunnel. interface Tunnel1001 no ip address no ip redirects ipv6 address 2001:1001:666F:726D::1/60 tunnel source GigabitEthernet0/1.1001 tunn...

hello, a while back we upgraded our cable isp to 50/10Mb setup at one of our remote offices. Since then our performance thru the Cisco 2801 has been pretty abysmal. Sometimes we can get 40 down but never more than 1Mb up. Sometimes, the download will...

Good Morning/Afternoon, I have been receiving the following errors.  Any reference material would be greatly appreciated. 6408: Ashe_CH_MDF_RTR: 249660: Feb 1 11:12:27.989: %VOICE_IEC-3-GW: C SCRIPTS: Internal Error (No dialpeer match): IEC=1.1.128...

In simple network as below Sw1----------R1-----------Sw2 Sw1 switch1 is connected with Sw2 switch through a R1 router. Suddenly Sw2 path broken but Sw1 getting Ping command successfully. Want to know the reason why is getting successful ping as pat...

We are going to have new data Circuit and the termination handover is G703 Unframed E1 service and i have vwic2-1mft-t1/e1 Card on my 2800 series router.I have the following questions1) How to configure ip on this interface is it same as RJ45 or any ...