Routing

Hello, I have a number of computers connected to a Cisco router, which in turn is connectedto an ISP via WAN.  I was wondering if I can send data, e.g FTP to my static outside ip addressfrom my LAN, or is it only possible for outside networks to acce...

Hi All, I have a question please. regarding the below network diagram, is it possible to create a /30 VLAN (no-vpc link, normal L3 link) between the 2 Nexus7000 in order to do routing between router, Nexus700-1 and Nexus7002???   thank you for your s...

Hi, Can anyone advise on the best practice/recommended method for creating iBGP peers between VRF's on different routers please?   I have two transit routers that are running a VRF to eBGP peer with our Internal network, and also eBGP peer out to an ...

Hi Team, We are installing Nexus switch to upgrade backbone performance from 1 Gig to 10 Gig. There will be both LAN (Vmware) and SAN traffic going through this switch. Need to know your suggestions on the same. The nexus will connect to existing L3 ...

Hello,We want to upgrade the IOS of 3825  from Version 15.1(4)M4 to Version 15.1(4)M10.Is it going to effect license features that are activated in 15.1(4M4) ?Regards, 

I need to configure my router for  three routes ( two separate fiber links and a radio link) with one of the fiber links being the primary link, the other fiber a secondary route and the radio a backup route for the fibers.I am looking for a best fai...

I ran into a situation where one interface on an ASA was linked to another partners router via a public IP in order to service a web portal application. The LAN side interface of the ASA is connected to a private address space, and the entire address...

Hi, I have configured BFD between two routers connected with a PPP Multilink bundle of T1's.  The routers (one ASR 1001-X, one ISR 4331) both take the commands, but the BFD session does not come up.  Both routers are running IOS-XE 3.16.00.  Here's t...

Hi,   on a multi-site installation, I've got some additional requirements to implement. Currently, two site (CPE) have a tagged ethernet service to a central site (PE). Now, apart from the L3 traffic, I need to bridge an additional VLAN from site 2...

I was trying to use "Top Talker" feature of Netflow on ASR 1001 running asr1001-universalk9.03.10.05.S.153-3.S5-ext.bin. My configuration is as below: flow monitor Temp record netflow ipv4 protocol-portinterface s0/1/0 ip flow monitor Temp output The...

Hi,at my company we have a remote site that is connected to our cisco ASA using a cisco 831 router. One the remote end they are using a fairly slow DSL connection.  We are trying to run some software on some clients and that software needs to update ...

I am attempting to build a redundant switch solution to one router using a BDI interface. This is from an ASR1002x to two 2960x switches. A diagram of my configuration is attached.In the diagram are 2 switches connected to the router using a single v...