Routing

Hello I recently purchased an ASR1002x. When I booted it up, I see the following error messages. I open up TAC and they state they will RMA it.I get the new device and then exact same messages appear in that as well. Please advise if these are ok, no...

Hi, I have 2 redudant ASA 5510 and 2 ISPs, with the new ISP I can't access the application URL but I can use VPN to access local servers, ping & SSH.below my configurations.:ASA Version 8.0(2)!hostname ACTIVE-SITE1enable password TBdKmmusfDZ7gglC enc...

Hi,Just to give one example on my local web server ip 192.168.1.237 i want to be outside adress port 80 direct to 192.168.1.237 port 80"ip nat inside source static tcp 192.168.1.237 80 interface GigabitEthernet0/0 80"and"ip nat inside source static t...

Unable to install ios software on 2801  c2800nm-tpgen+adventerprisek9-.mz.PAGENT.4.8.0.bin

 1)how can i reset the cisco ASA 5505 router password ?2) i have created tunnel between the router its working but like that i have created other router its not transferring data. 

Community,  I am having issues with a an 1841 router dropping tcp packet segments. The packet profile in question comes in segments of 1348 and 802. The second frame is not being sent out of the egress FastEthernet interface. The packet is then sent ...

hi, I am trying to configure traffic shaping on 100Mb wan circuit. and normal traffic is 60 Mb on production hour. Not sure how to calculate shaping bit value for 100 meg circuit. can anyone help.

Can anyone send me a template for a Cisco 1921 router?  (only the 1941 is on the Cisco download site).\Would prefer a 2-D version . . . You can email it direct to me bill.higgins@expeditors.comthks,    - Bill H

I cannot see any entries on the NAT translations; anyone can advice please? for the .25 ip address but can see for the .1ip access-list extended POLICYNAT permit ip host 172.16.2.25 172.17.37.176 0.0.0.15 permit ip host 172.16.2.25 172.17.37.192 0.0....

Hello and Good Evening                            My Question is really simple...... Why does Rip has a HOP count limit of 15? any technical reason apart from that it is desgined for small size network... and Can we tweak or change this behavior by a...

Hello,     I have been reading some articles, and blogs, about accessing the VTY lines when the traffic is coming from an interface that is apart of a VRF. According to what I have read, you should not be able connected to the VTY line unless you put...

Hi All, I have Cisco 2851 router , having a problem with high cpu usage without having much of a traffic. Could some one help ?? show proc cpu sortedCPU utilization for five seconds: 98%/95%; one minute: 98%; five minutes: 97% PID Runtime(ms)     Inv...

Hi,Has anyone experienced on provisioning L3 MPLS link for Storage Replication.  I have two DC at different location and EMC Storage.we will have 2 MPLS L3 Link between two DCs to replicate the data.  We have 4 RPA at each side and 2 MPLS Link.  but ...