Routing

Hello,Is it necessary to do MD5 between eBGP on p2p private link?thanks,chanty

Hi guys,We want to connect one of the CE routers to two our PE's (active/standby, no loadbalancing) and use dynamic protocol for route exchange.Both PE's and CE share the same subnet.What are our options? Can we use HSRP, make one PE active and align...

Hi there, I have a strange problem concerning a Cisco 3925:Cisco IOS Software, C3900 Software (C3900-UNIVERSALK9-M), Version15.1(4)M, RELEASE SOFTWARE (fc1)(c3900-universalk9-mz.SPA.151-4.M.bin)This router has 3 native interfaces: Gi0/0 (RJ45)Gi0/1 (...

Hello All, I need assistance in shaping bandwidth over DMVPN. I tried to configure some QOS policy but it doesnt detect properly. Here are my Ranges : DMVPN Tunnel = 192.168.100.0/24Inside Network Range = 10.10.10.0/24Remote Server accessed over DMVP...

We have OTV working on our ASR1Ks in a lab environment. We mocked up two data centers and a simulated ISP core that supports multicast. Everything works fine. We can move hosts between data centers, drop a few pings and see the OTV table updates and ...

Hi,I am trying to add additional block of 4 public IP address to UC540.When trying to create NAT pool, i am receiving error the new range is not in the same subnet as WAN.Current WAN subnet is /30, but new block of IP's change after first 2 octets.Ob...

Hi,I've got a full t1 circuit problem I cannot resolve. I don't manage the device at the other end of the circuit.  Config for both of my routers is the barest minimum on both routers:!interface Serial0/0 bandwidth 1536 ip address xx.yy.xxx.zzz 255.2...

I'm attempting to install an IOS image (about 53 MB in size) on the flash of a 2811 router, however the transfer times out after 32 MB have been transferred. I've tried two different tftp server software packages with the same result. Does the tftp...

Hello, I have a Ethernet module (SM-ES3G-16-P) installed in a 3945 router and noticed during first boot no licenses are active at all. I would assume at a mimimum ipbase would be active. With this module, does static routing work with just ipbase?Exa...

   From Router 3925 which it has SM-ES3G-16-P etherswitch module from that module we have connect three more router in which is in different locations. I configured switch module and other end router i am able to ping each other. But i am able to pin...

Hello! I have configured 1700 series router to forward workstation traffic through one port and the voice through another. The Configuration is pretty straight forward, but we experience a major problems. When the SIP phones plugged in to the switch ...

I want to buy cisco c3750x switch between WS-C3750X-24P-L with WS-C3750X-24T-L . I still have no idea to choose which one is worth to have, can someone give me the suggest?