Routing

I'm buying a 2900 series router.  I need security (IPSEC VPNs), CME,CUBE and SRST.Which bundle should I buy?  I'm thinking VSEC-CUBE and add a line item for SRST?If I just ordered the UC bundle, what would I need to add?  A security license and CUBE/...

Hello everyone, I have a router on a stick with several vlans, several sub inerfaces with do1q encapsulation..My problem is that a internal host on any vlan can ping any router interface but the router cannot ping the host back.I'm attaching my runni...

Hi All,I am trying to configure my cisco asa firewall . we have both 5505 and 5515.I know most of the commands but want to learn all funtionalities of the asa so have set the time aside to read through the document.so i went to read the following htt...

                   I'm not an expert on cisco devices, so I will explain my situation in order to allow you to suggest me the best way to proceed:I have a known working configuration with many sites and one operative center that receives all communic...

I´m facing a confuse problem. maybe the solution is simple but i can´t find it.the show policy map shows an offered rate far above the target shape rateshow policy-map interface tunnel 204 Tunnel204   Service-policy output: BA-DBNA-BRANCH-OUT-2M    C...

Hi.I've been asked to configure a C887VAGW router with a DSL service and a 3G backup modem for internet traffic by my boss.He wants a whole shitload of stuff on it (at least two wireless SSID's, VPN's, god knows what else) which I can mainly figure o...

I am tasked with migrating our WAN from Microwave T1 multilinks (2 each endpoint), over to a fiber backbone.  We are getting 100Mb at each site with 1 fiber port from the provider.  My supervisor doesn't want to "re-invent the wheel" but wants to get...

Hello,we have a T1 from a internet carrier connected to serial0/0/0:0.  This interface is setup w/ the carrier as ip unnumbered to ip block 12.34.56.0/24.  We also want to run NAT overload the inside clients to 12.34.56.1 or 12.34.56.10 and run CBAC ...

Hi All,The basic definition of fast switching says that whenever there is a new packet on the ingress interface  the first packet is always process switched and outbound interface and a MAC header for this destination is tsored in a fast cache. The n...

Dears,I am looking for a solution to bundle multiples MPLS layer-2 circuits using CISCO Routers to have a heigher capcity of total circuits. For example, bundling 2 MPLS circuits each of them with capacity 2 Mbps using two PEPlink boxes to have 4 Mbp...

                   I need to create a access list to allow only the indian user. what is best way to configured it.  Actually i collected the Indian Public IPS and creating access-list permit those public IP only implicit deny will block other countr...

Can any one advice please difference in speed capabilities for V.35 as compared to X.21 cables?

I have been tasked with designing ISDN backup for my three branch offices.I have one head office.If one of my sites looses ADSL I need the branch office to dial the head office on a 256k bonded ISDN.I can find configs for one to one dial in, but not ...