Routing

Hello everyone, this is my first post so sorry if I posted in the wrong area, but here is a little info on my situation:I have (3) 2811 connected via frame relay switch (3745). The 3745 has (3) VWIC-2MFT-T1'sHQ 2811 has (1) VWIC2-2MFT-T1/E1Branch1 28...

Hello AllI would be grateful if someone could please provide some information on the following:I am trying to troubleshoot dropped packets issues over a Serial link using ppp multilink;one issue i am seeing which seems strange is that althought the S...

We have a point to point GRE tunnel which has some issues that I would like to see if I can get some guidance.  When clients connect to the WLAN and are routed thru this tunnel they experience latency on some https applications.  However if you chang...

I have a Cisco 1841 that has an ADSL (ATM) card installed.  It was previously used with an ADSL line to provide NAT routing for an office.  Now I want to use it witha cable modem, which would mean abandoning the ADSL interface and instead routing bet...

                   HiI have a problem and I dont know much on Cisco ProductsThe router is Cisco 887 VAWhen it starts the Leds Ok AND  Fe lan are blinkng then are always on .After  10 seconds lan led is off a and  pc shows  cable is unplugged I tried ...

Hi All,Just a quick question, i have a 2911 as stated above which come with a base IOS of: c2900-universalk9-mz.SPA.152-4.M2.binI have downgraded the image to: c2900-universalk9-mz.SPA.150-1.M7.bin, however when the router initially boots i receive:c...

hi,PLEASE HELP, I am getting desperate to resolve this. ThanksI have 2 887va routers which are both connected to an ADSL line and I have set them up to pass layer 2 traffic via L2TP.I am injecting layer 2 traffic into one of the routers using Colasof...

HelloI'm using a pair of cisco 7200 with NPE-G2 router for my VoIP operation. I'm facing a high interrupt situation where running around total 100k Ingress packet per second, but running at around 55% Interrupt CPU, and when have 250k Ingress PPS, it...

I currently have two sites that are connected via a 100mb metro e (NLAN) connection, but I will be adding a new site temporarily during a move. I have a router on each end of the current metro e connection and each site has different VLANs and subnet...

I just purchased Comcast Fiber EDI service. Comcast delivers this service on a /30 network and a /27 network. The customer (me) has to route the /27 network through the /30 network .Here’s an example of the IP’s they gave me:10.202.187.128/30       S...