Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Labels

Forum Posts

Dear Firends,I have problem of Site to Site connectivity  I have 2 sites (Site 1' public ip. 115.119.120.X, local ips are 192.168.1.0, & Site 2' public ip 115.119.187.X, local ips are 192.168.2.0)Both sires are having different locations & using rout...

Hi.I've got an 887M router which will be configured with two linke - one ADSL, one 3G - both of which will have (obviously) a separately suppplied IP address from the different ISP's being used. The 3G is a backup - plain and simple - for use only wh...

darren.g by Level 5
  • 978 Views
  • 1 replies
  • 0 Helpful votes

I am replacing some WAN connections: Point to Point T1's (running from 2820's to a 7200).  I am replacing them with metro Ethernet connections with a 3560 layer 3 switch at each end.  We run Cisco Call Manager, and have IP phones at our locations.  I...

Greetings Experts!I have a lab that we are trying to configure in such a way that it simulates our real world setup.  We have many individual nodes that are connected to us via satellite and thus, have very slow connections.  I would like to know if ...

Hi all,I have a 2911 that will be using a 4G wireless card. It seems that it'll need to get a DHCP address from Verizon (even though we requested a static). I'm trying to configure the cellular interface to get the DHCP address using the "ip add dhcp...

aweise by Level 1
  • 1183 Views
  • 2 replies
  • 0 Helpful votes

Can someone help me on identifying the source of high cpu on my router?sh verCisco IOS Software, C2600 Software (C2600-ADVIPSERVICESK9-M), Version 12.4(15)T14, RELEASE SOFTWARE (fc2)Technical Support: http://www.cisco.com/techsupportCopyright (c) 198...

Resolved! Connection problem

Hello everyone,I have a 2611XM router that im trying to connect to the internet. Basically its set up below.*Cable Modem plugs into my router F0/0 port.*Router F0/1 plugs into my switch(2950G) port one and then port 2 is then plugged into my computer...

My HUB location have the two router and Two WAN link,one on each.spoc location also have the same thing.1.In HUB location for LAN we are using a HSRP and at spoc location also we are using HSRP for LAN.2.for primary router i am using a BGP protocol a...