Hi We have Cisco 2911 router with image flash:/c2900-universalk9-mz.SPA.151-2.T2.binlicense is ipbase.----------------------------------------------------------------Technology Technology-package Technology-package Current ...
Hi We have Cisco 2911 router with image flash:/c2900-universalk9-mz.SPA.151-2.T2.binlicense is ipbase.----------------------------------------------------------------Technology Technology-package Technology-package Current ...
Hello everyone,I'm facing a problem in the topology attached.We connected to a partner (callcenter) using a /30 point-to-point with public addressing. We will not mix our internal addressing.R3 is partner's router, R1 in HQ router, R2 is our companie...
Hi all, Trying to get the boot system flash bootflash: command to work so I can change code versions if the latest one begins to have issues I can easily roll back. I enter the command:boot system flash bootflash:asr1000rp1-advipservicesk9.03.03.01....
Hi All,While studying about EIGRP I found this diagram online & was confused by the description of how EIGRP chooses its best route...Can some one please tell from the diagram, what would be the Advertised Distance, Reported Distance & Feasible Dista...
Hi I wonder if anyone can help. I have an router with MPLs configured, that is a subinterface from my wan connection eg.interface fastethernet0ip address 1.1.1.1interface 0.200encapsulation dot1Q 200ip address 2.2.2.2On the lan side...
Friends here is scenario,Suppose I have connectivity between CE and PE through a Gig Circuit like belowCE-------------------------------------------PE And bgp is configured on both ends but there is also a secondary CE and that is connected to other ...
Good day everyone,ive seen a lot of examples of the above subject but i would like to have some clarification on an existing lab configuration issue we are having. first off, im by no means an expert hence reaching out here we have a customer that ha...
Hi guys,I have set up a lab (see below) and wondering if someone can shed some light on it. My task is to understand MTU with pseudowire setup between two routers. Two routers connected via point-to point link (In between is our partner ISP), the rou...
Hi,While I am debuging ICMP traffic originated from a router ( Debug ip packet details) it is showing packets routed via FIB and reply is showing as routed via RIB .is it means ICMP packet originating from the router is CEF switched ? if it does ...
Dear AllI'm a bit confuse of the Packet Per Second performance measurement from Cisco. Does it calculated based on All Interface In PPS + All Interface Out PPS = Datasheet Packet Per second?Or just take the In PPS of All Interface.ThanksBenny
Hi All,We have a static route that is redistributed with metric 1 in to OSPF and it is properly advertised on all routers. But we want to one router to be exception. We do not want this static route on this router. Below is the config on my router. r...
I have been asked to configure a spare cisco to act as a bridge between 2 local networks. I have created a simply config with a static NAT from one specific device (on the 192 network) to the device on the 10.10.64 network. It works a treat. The p...
Hi,We get this alert very frequently on Cisco 2900 router. Does this indicates the module is flapping. ? Do we need to open TAC case to investigate on this.Please help me on this.sh diagSlot 0: C2901 Mother board 2GE, integrated VPN and 4W Por...
Hello,Does anyone have a good link that explains the NX-OS upgrade path? I am trying to go from 5.0(2a) to 5.2x.Thanks
I have an ASA5510, and site-to-site VPN with several remote clients. I have to add another client but their network range overlaps an existing tunnel. Both are using 172.16.0.0/16. I would like to 1-to-1 NAT them as 172.17.0.0/16. Is it possible to p...
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
Subject | Author | Posted |
---|---|---|
10-17-2024 11:42 AM | ||
10-16-2024 07:21 AM | ||
10-16-2024 12:58 AM | ||
10-15-2024 08:44 AM | ||
10-10-2024 12:41 AM |
User | Count |
---|---|
12 | |
9 | |
7 | |
6 | |
6 |