Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

I have a question about BGP pre-pending that I am hoping someone might be able to help with...I have an internet connection to an ISP A (single homed) where we advertise multiple Class C networks.At the same location I also have another internet conn...

Resolved! Evaluate Firewall

Hello Expert,We want to evaluate the firewall with different vendors, what  do we need to compare with? The check list is appriciated.Regards,Joe

Joe Lee by Level 1
  • 859 Views
  • 3 replies
  • 0 Helpful votes

Hi all,I would appreciate if you can help me w/ the following problem.Perhaps it sounds a little bit weird. Is there any way to filter some of Neighbors(learned through OSPF) in BFD sessions based on Neighbor IP(and not on interface)?I would like to ...

ecitele10 by Level 1
  • 3639 Views
  • 4 replies
  • 0 Helpful votes

Hello, I have a cisco 1800 which I'm trying to get nat working on. See running config and software info below. I have 1 public (internet) and I have a couple of subnets on the inside, of which one is directly connected; 192.168.1.x. My pc from where ...

michellp by Level 1
  • 3334 Views
  • 4 replies
  • 0 Helpful votes

hello expert,  I want the load balancing on ospf network that 1. subnet 1.1.1.0/24 reach at destination through  int fa0/0 (Router R4) 2. Subnet 11.11.11.0/24 reach at destination through int fa0/1 (Router R4).I am not using any ospf cost or bandwidt...

Hello CISCO experts,Im planning for a network upgrade.current situation: ------------------- cisco 1841 -----------> 3COM none managable switch -------> users, servers, printers-------------------                       77.110.87.112/28 - is assigned...

                   Hi ALL,We have a need to access an VLAN at the main office( ie Core Switch 6500,switch 3750) from a remote site(Cisco3845 router, Switch3750) connecting by a SP through fibre link.what is the easiest and quick way to do it and the ...

q-le by Level 2
  • 1470 Views
  • 6 replies
  • 0 Helpful votes

We have several Cisco Nexus 2248 going back to Nexus 5596. My question is, if you have a 2248 in production and it fails, what is the process when you swap the appliance out? Will the 5596 hold the information or I'll you need to push the config late...

Hi,Trying to setup Dual VLAN (Different Subnet for Wired and Wireless) on 877w for and seem to be stuck somewhere where VLAN2 is stuck on up/downWIRED - Vlan1 - 192.168.1.1 / 24WIRELESS - Vlan2 - 10.0.0.1 /24I have disabled all the bridiging and all ...

Hi all,I need to know if is it possible to use ebgp multihop on a CE with two links, one link is connected to PE1 and the other link is connected to PE2 (one CE with 2 links to two different PEs).thanks

Gentlemen, I have cisco 2911 with IOS-universalK9 mz.SPA.150.1.T, but that does not accept the ip sla monitor commands XX, XX or rtr ip sla XX. How active these commands in IOS or what you belong to? TksAndre E Biliati