Routing

HIBy default 2900 Router have maximum 225 IPsec Tunnel. My customer Requirement 500 VPN Tunnel.I know HSEC license enable the extended Tunnel for 2921 and 2951.My confusion is:    If I take 2921-Sec/k9 then addtional take FL-29-HSEC-K9  ?? or  2921-H...

Troubleshooting WAN Links Using QoS with Sarala Akella Welcome to the Cisco Support Community Ask the Expert conversation. This is an opportunity to learn how to troubleshoot congestion on WAN links by using QoS and buffering best practices to optim...

Hello Experts,I have enabled all snmp traps on 6500 switch,i want to know the description of each trap and severty level for each trap,where can i find it???can anybody route me to the proper document.Thanks,snmp-server system-shutdownsnmp-server ena...

Hi,I am having trouble getting some multicast traffic across a link.  I have a 3750G setup, with IP routing and IP multicast routing, between two laptops.  This will eventually sit between two networks that cannot be physically connected to each othe...

Hi AllI have a cisco 1841 router and want to run BFD i think it needs IOS 12.4TIt has currently 12.4 but no T does the "T" IOS have mroe features?thanksBen

We are weighing devices for running 700+ site to site VPN connections.  The debate is over ASA vs 3900 Series Router.  Any strong feelings?

Hi everyone  There some layer 2 and layer 3 Cisco Switchs our network,And there is other project,the project about logging.I want to take some Log reports from these switchs,Which logs can ı take? For example : Which switch ports Most Port changed?

To anyone I have Tight VNC installed on users laptops. They have Tight VNC with port 5900.Problem is that I am not able to connect to there laptop when I am in the office and they are at home or traveling.They connect to our office network using our ...

We are planing to implement the WAN QoS polic to apply on the routers for sites. They all are connected to our service provider via MPLS. We will make policy for voice, video and data. We have Cisco VoIP phones and some other equipments for voice, an...

Hello all,I'm currently in the process of doing a bandwidth analysis on 2 WAN links at my current HQ / remote sites.  The topology is pretty straightforward, two 3845 routers at HQ, and two 3845 routers at my remote site, both with P2P DS3 interfaces...

Probably an easy question for the experts, but I haven't been able to make this work. I have a site-to-site IPsec tunnel between the main office and branch. It terminates on an ASA at the main and on an 880 at the branch. I now have a need to route a...

All,I'm running a bgp lab where I'm trying to force BGP to route specific static routes to specifi neighbor I created a prefix-list & route-map for the static addresses, applied it under bg....Nothing....bgp is not sending out the routes.Waht I'm mis...

I have a set of stacked Cisco 3750v2 switches which are running QOS with a bandwidth limiting service policy.  The switch is configured as follows - I have a /26 internet routable address space similar to the following 1.1.1.64/26 (used as an example...