Routing

I have problem trying to set up an ATM CBR VP. The service provider has specified CDVT value of 445 for my CBR 1024Kbs path (which is on a STM-1 link). The STM-1 is connected to a LS1010 and this in turn is connected to a non-Cisco Router. After some...

We have a point to point T1 from Verizon using a clock source on the one side (uses the standard command: service-module t1 clock source internal). Both routers are 1601R's and they are both running version 12.0(8). We have had these routers in pla...

We have 3 connections to different ISPs on cisco 7507 (3 different AS) and a BGP. There is no transmission between ISPs only between LAN interfaces and internet. I wonder if there is any point to connect ISPs to VIP cards. From theoretical point of v...

I have a question I am hoping someone can help me with. I set up Multilink PPP for location and I now have to do it for one of my other remote offices because we are adding a second T and want them to act as one. My question is, can I add the code re...

We have a cisco 1841 router with an ADSL WIC. The LAN is connected to f0/0 and a T1 connection goes to f0/1. This is how traffic flow should be: -Internet traffic should go over the dsl-If the dsl is down, internet traffic should go over the T1-Intra...

Hi I have 1721 router with 12.2 IOS.Mrtg from the ISP shows high download during the weekendsI would like to know which machines from the lan, which portocol and which port etc.. is doin. I would like to track and stop.What are my options. I have tri...

Can anyone advise how to obtain the chassis serial number of a 7200vxr router from the CLI?Many thanksJason

Hi, I have 2 6006 core router. and my all process router is connected to CORE.CORE1--CORE2 right now 2600 router is connected to only 1 core. so redundancy is not there for router. shall i configure priority or metric for static route. i me...

I have an leased line,the modem has been terminated on an serial interface say on WIC-2T through V.35 cable, when i issue and sh int it says Serial Down and Line protocol Down, the DCD-Up, DSR-UP, DTR-Down, RTS-Down, CTS-Down. Can any one give ...

I have here a cbwfq config on a 384kbps pvc. I don't understand why the router says there is 96kbps bandwidth available. Could someone explain?router#sh queueing int atm1/0.14 vc 0/113 Interface ATM1/0.14 VC 0/113 Queueing strategy: weighted fair ...

Hi peple,Thing is, I have 50 users LAN and a Pix just to go Inernet, then I´ve been publicing some services, inside my network I have an aditional 2611 router for remote access inside my network which is everybody default gateway, ok but, I need to ...

Hi, I have 2 routers in site A and 2 paths to get site B. EIGRP is running between them. Here is output of the command:show ip eigrp topology 172.30.0.0/23:show ip eigrp topology 172.30.0.0/23IP-EIGRP (AS 1): Topology entry for 172.30.0.0/23 State i...

Anyone know where to get the distance information for the following module? Thanks a lot.OSM-10C48-POS-SS+OSM-10C48-POS-SI+OSM-10C48-POS-SL+