Routing

Guys,I am in need of some big help. TAC can't help me because they do not get involved in design; they only do break/fix. I totally understand that.I got a simple office: one flat LAN, one single 1841 router and 2 ISPs.LAN is 10.10.20.0/24 and is con...

I have a Cisco 2911 that I am configuring for a remote site.  I have configured a IPSec Tunnel from our main site ( ASA 5510 ).  The Tunnel is up and I can connect from the main site LAN to the address of the 2911 through the IPSec Tunnel.  The 2911 ...

Hello everyone,I have a UC 500 series router and today it restarted on its own and i received following after doing show version:System returned to ROM by error - a Software forced crash, PC 0x8019A63C at 14:0                       5:50 UTC Tue Feb 1...

Hi Netprowhicj of the below line the router process first?pls a bit explanationip route 1.2.3.4 255.255.255.255 4.4.4.4ip route 1.2.3.0 255.255.255.0 4.4.4.4.4thanks

Hi NetproPls can y expert help me to Maintain and administer asr 2 asr routers connected to two different isps , so that no no impact for business in term of reliabilty  and performancethanks

I have a question, it is possible to have two WAN interfaces to configure a cisco 892 routerwith an ip 255.255.240.0 84.197.167.111 adderess of the first interface and a different ip address 84.197.174.182 255.255.240.0 on the second interface

Hi Guys,Im having a little trouble with a router I have got my hands on to practice for my CCNA.Im connected via serial>USB adapter and via XP HT on Win7.Router boots and I then break the boot sequence with ctrl-break. But then it does not go into RO...

Hi,I have a ASR 1004 with the following int:1 x Cisco 8-Port   Gigabit Ethernet Shared Port Adapter2 x Cisco 1-Port 10GE LAN-PHY Shared Port Adapter1. Can I do a backup int in 1 of the 8 Port gigabit ethernet port to backup another port in the same m...

Dear AllI know who can help me to configure my cisco 892 routerwant a static ip address assigned to the interface becauseand I have no more internet on the routerbecause am working on my network academy for CCENT Please help!

No idea if this is the place to ask, but I cannot figure this out. Got 3 3750's, and a bunch of ME3400 switches. One of the 3750 runs a dhcp server, but the problem is, I keep seeing that it's very, very hard for clients to actually get an IP. Someti...

Hi!I have a customer that is running a 2911 with a VWIC2-2MFT-T1/E1 card. This is going to be connected to a ISDN E1 PRI from the public operator. The output from the PRI box is 120ohm. My question is can I use a standard Cat5e cable for this connect...

HiI need to configure a Cisco 877 router like a bridge. I have a firewall SA520 before the cisco 877.I need to configure the public IP on the interface WAN on the firewall, and I can´t configure any NAT on the router.I try to configure the cisco 877 ...

Hi. I have two Cat6506 (redundant collapsed-core config) configured  w/  RPVST+ and connected to this are a series of Cat2950s configured  with  PVST.  My question is, is this a good practice configuration of  STP? If not whats the best practise .Wha...