Routing

I have a client requiring a router to act as the gateway for their multitenant office building. There will be approx 60-80 users that will share a 10mb fiber connection. Some tenant will require a static external ip while other will only require basi...

Hello,Please see attached config. and topology layout. (ignore AS 30)Both Meribel and Lillehammer runs RIP as an internal IGP in their AS's and both routers runs RIP on the serial interfaces that are connecting them. In this scenario, i want to use B...

hello,i would like to do a bandwidth test for a certain application (http) in order to specify the required bandwidth needed on the internet link.so i want to simulate an internet link for a 2 gbps to see the response time.i would like to check if ra...

I have a policy that first shapes the traffic to the correct bandwidth, then applies LLQ, then of course the cos_out has ef, af41, etc with different bandwidths.  So my question is I'm seeing a lot of buffer drops, are these packets being dropped bef...

I have been failing PCI compliance test I keep getting "firewall UDP packet source port 53 ruleset bypass" anybody else getting this or know what setting to use to prevent it? I have a linksys wrvs4400n router. thanks

HIBy default 2900 Router have maximum 225 IPsec Tunnel. My customer Requirement 500 VPN Tunnel.I know HSEC license enable the extended Tunnel for 2921 and 2951.My confusion is:    If I take 2921-Sec/k9 then addtional take FL-29-HSEC-K9  ?? or  2921-H...

Troubleshooting WAN Links Using QoS with Sarala Akella Welcome to the Cisco Support Community Ask the Expert conversation. This is an opportunity to learn how to troubleshoot congestion on WAN links by using QoS and buffering best practices to optim...

Hello Experts,I have enabled all snmp traps on 6500 switch,i want to know the description of each trap and severty level for each trap,where can i find it???can anybody route me to the proper document.Thanks,snmp-server system-shutdownsnmp-server ena...

Hi,I am having trouble getting some multicast traffic across a link.  I have a 3750G setup, with IP routing and IP multicast routing, between two laptops.  This will eventually sit between two networks that cannot be physically connected to each othe...

Hi AllI have a cisco 1841 router and want to run BFD i think it needs IOS 12.4TIt has currently 12.4 but no T does the "T" IOS have mroe features?thanksBen

We are weighing devices for running 700+ site to site VPN connections.  The debate is over ASA vs 3900 Series Router.  Any strong feelings?

Hi everyone  There some layer 2 and layer 3 Cisco Switchs our network,And there is other project,the project about logging.I want to take some Log reports from these switchs,Which logs can ı take? For example : Which switch ports Most Port changed?