Routing

Hi Team we have one cisco 871 and five cisco 851 routers , all those routers are connected to each other using site to site VPN tunnels, so each router have 5 tunnels, we are usong thhese routers for IP phones, each location have 2-3 IP phones and 2-...

Hello,I am trying to put a configuration together whereby my internal host 10.10.10.1 can access external host 172.16.1.1 and vice versa by using NAT addressing.Essentially I set up a router with the following configuration –!interface FastEthernet0/...

  I have a comcast business class cable modem and am trying to connect it to my cisco 2821 to route only certain types of traffic.  Is this possible?

Hello,how monitor hardware queue on ethernet interface (after applying tx-ring-limit command)?Regards,Mike

hi,i am very new for WAN failover configuration so any one can u please tell me how to configure cisco router 1841 with two WAN linkplease give me step by step thanks in advanceMahesh Patidar

HiUp til now, I have only had one management network, flat L2 with no routing.I`ts getting to big now, and I`m splitting it up in several segments.Need routing between the networks, but it should not be reched by any other networks that the managemen...

hello,I have a 2621 XM router with an ADSL WIC and WIC ethernet.I use that, and 2 as all WAN.erhernet as the principal and the ADSL fail over in case of Ethernet.is possible with this router? if so, how can I configure it?Thanks to allDaniel

Hi all.I have a customer which has topo network like this picture. From FTP A, I can upload any file to FTP C, but I only download (via using FTP service) .rar file from FTP C, and it's impossible to download any other file types. With an .exe file, ...

Hello folks,  a customer of us asked if C2911 (to be bought) is ok for partial BGP routes.This is the situation:2 cisco 2911, each peering with 3 other AS (AS1, AS2, AS3), and maybe, in the future, at a small IXP (AS4, AS5, AS6, AS7).They will accept...

Hello NetproI want to isolate Guest user traffic from LAN traffic and allow them internet only. All internet browsing traffic is through Microsoft ISA Server.Guest can connect using Wireless Access Point which is also shared with Data Network.Microso...

Hi All,We have 3845 Router which is using for only Internet connectivity with one ISPScenario:ISP1 ----Cisco 3845----IPS-------- Cisco ASA5580-20-----Cisco 4510R-----2960                                                                                ...

Hi,I need to be able to do RDP down an IPSEC tunnel between 2 877 routers (Site to Site VPN) as well as allow RDP in from the internet interface.so I have a ip nat source static tcp 192.168.1.5 3389 interface dialer0 3389to permit the external traffi...