Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

Dear All,What is the best practice of the routing for LAN and WAN,Is it OSPF & BGP or EIGRP & BGP?Really appreciated for any reply.Regards,sam

sam_manay by Level 1
  • 2340 Views
  • 3 replies
  • 0 Helpful votes

Hello Everyone,I'm hoping someone will be able to help me figure out an issue that I'm having. I'm sure it's something simple that I'm missing.  What I have is a site to site vpn tunnel between a Cisco 2801 and a Cisco 1841 router.  The tunnel itself...

I am going through several devices where static routes have been used and I am migrating them to EIGRP internally. I want to know of a command I can use on the routers to verify that once I remove the static route EIGRP knows about the routes and wil...

Hi all. I have a customer with a 5510 ASA and they only have one public ip address. They need to terminate the annex M adsl on a 877ISR. Does anyone have a sample configuration that will allow me to pass the ip address from the 877 onto the ASA? All ...

mbluemel by Level 1
  • 1226 Views
  • 1 replies
  • 0 Helpful votes

hello everyone,i am trying to find a solution to have DMVPN tunnel running between our corporate and our ISP.however they current running protocol between us and ISP is OSPF process 10, announcing internal LAN and WAN IP addresses.how can i have anot...

Anyone who can explain to me the below tracetcp and tracert that I have gathered. From hop 4-12 show high latency but at the end it shows low latency result, is this acceptable? why at middle show high latency values? Thanks1       1 ms    1 ms    1 ...

Hi Experts,We have installed an HWIC-4ESW card on a Cisco 2801 router in SLOT#0. However the card is not getting detected.The IOS version is 12.4(13r)T .Can you please advise if there is something we are missing here. Does it needs to go into a speci...

Hi,We are currently doing performance test of our application that is currently on staging and production stage. Does anyone knows of a tool that can measure how well the application will perform on a certain network condition? Or how to best trouble...

Hi all,I have Cisco 3750-24PS-S switch, which IOS mistakenly erase, I have run switch:format flash: command also,I tried Xmodem recovery for upload IOS on flash, but it gives I/O error while uploading the IOS,So plz give the complete procedure for IO...