Routing

Hi,i executed "traceroute 10.71.252.18" and the result isinternalrouter#traceroute 10.71.252.18Type escape sequence to abort.Tracing the route to 10.71.252.18  1 10.71.0.34 132 msec    10.71.0.30 136 msec    10.71.0.34 132 msec  2 10.64.128.42 136 ms...

Hello,Happy New Year to all! Thanks so much for the privilege to learn from you all, I am ever grateful for your wealth of experience which you have always shared with this community.I will like to know how to log in to my router using secure shell l...

Hi experts, i have 871 with IOS 12.4(24)T advIPservices. flash memory is 28MB and the proc memory is 128MB. The problem is that the free processor memory decreases and after some period of time (2-3 days) the router is overloaded. After restart, the ...

Hello,I have configured DNS forwarding on my Cisco 2821 to ISP DNS servers and configured router as a DNS Server for all of desktops/laptops I use. Everything work correct but only for 48 hours (approximately), then I cannot access/ping several websi...

Hi,I configured switch interface to switchport security in sticky mode with violation is restricted. The snmp traps are continously sending to log server if violation occur. I want to fix the snmp trap only one time if any violation in mac-address. A...

Hi, A customer has a Cisco 2821 router with two ethernet interfaces and two HWIC interfaces connected to different ISPs.Interface G0/0 has private IP address 10.10.10.10.Interface G0/1 has a public IP address from a pool of IP addresses from ISP-A.Di...

Hello,I have a problem with my ps3, when I do a test network connection, it fails in the test internet connection step, it shows 80710102 dns error.The IP of my router is 192.168.1.1, the IP of my ps3 is 192.168.1.20. I have a laptop with 192.168.1.2...

Helo, everyone i have a problem with my Cat6500 sup2/msfc2/pfc2The approximate topologi is such:PC(ip=10.0.5.254)---dummy switch---Cat6500.Initial Catalyst port(to which pc is connected) in set to L2 access vlan 700, vlan700 SVI have ip unnumbered co...

Cisco IOS QOS Solutions Configuration Guide, Release 12.4 says WFQ is enabled by default on interfaces configured for Multilink PPP.But when I "show interface" on the multilink interface I see:Queueing strategy: fifoOddly, the two T1 serial interface...

I'm facing a issues since couple of months.. I'm running EIGRP in our network and OSPF on MPLS network(connceted to our network), redistributing static routes in both.the problem is that even though i remove some static routes my network is taking th...

After a lot of digging about, I've found out that my ISP has switched me to another ISP network (nice of them to tell me). My username has changed and my once static ip address now needs to be obtained automatically from my ISP. Can someone please re...

Dear All,I just need to confirm that either 1861 CME routers support switchport port-security .... commands are available???If yes then on which IOS and if not then what is the alternate to fix the port security on the 8-port ethernet card?thanks,

Hi,We have a primary WAN network as a MPLS and Backup network as a Spoke to Spoke DMVPN cloud over internet link using two seperate routers.1. Router 1 --> EIGRP AS 1 on the LAN and BGP on WAN at MPLS2. Router 2 --> EIGRP AS 1 on the LAN and EIGRP AS...