Routing

                        Hello Guys,                                        I have 2 routers running OSPF I one network that connects to a bgp network and and trying to ping from my OSPF stub router to the iBGP network however the ping fails. I can pi...

My branch office 1760 router currently conencted over the Internet VPN tunnel to Headoffice. All traffic come thr the VPN and internet traffic directly go to the internet at the branch office Internet link.But my dns servers are Headoffice dns server...

Hello everybody,I need one router with some hardware specs as follow:- The router need at least 5 100FX or 1000FX ports, Fiber must be SingleMode, SC conector.All other specs are compatible with 1841, but as I see this model can have only 1 fiber por...

Hello Guys!is there any new release for the cisco product reference guide,i have the 2009 version but its not updated and it havsen't products like 2900 and 3900 series routerswww.cisco.com/go/guideThanks

Sir,Following is the output of my E3 controller.What is the meaning of E3 9/1/0 is up.How to avoid   11 P-bit Err Secs, 11 P-bit Severely Err Secs,      11 Severely Err Framing Secs, 71 Unavailable Secs,      0 Line Errored Secs, 11 C-bit Errored Sec...

Hi All,I have 1841 and configured below client vpncrypto isakmp client configuration group xxxxx key xxxxxxxxxxx dns 10.28.x.xx 10.12.x.xx wins 10.28.x.xx domain xxxxxx pool GBIT acl 2001ip local pool GBIT 192.168.xxx.xxx 192.168.xxx.xxxaccess-list 2...

HiConsider I got static NAT for a host on ASA, then  traffic from outside to inside is DNAT and traffic inside to outside is   SNAT.Is the above correctThanksMel

Quick question...This is the scenario.large enterprise2 Internet routers, each running eBGP with a different ISP than the other. iBGP between them.How does the enterprise obtain a public IP address space that would be advertised by both ISPs?usually ...

SLOT 4/0: *Apr 1 22:28:12.843 UTC: %BACKPLANE_BUS_ASIC-4-DEV_RESET: Backplane Bus Asic reset, interrupt [0x0150]=0x0900SLOT 4/0: *Apr 1 22:28:12.843 UTC: %BACKPLANE_BUS_ASIC-4-DEV_RESET: Backplane Bus Asic reset, interrupt [0x0150]=0x0800 SLOT 7/0: *...

Hi,I have read that the minimum memory requirement for full BGP routing table is 512MB. I have a router with 512MB memory, but the show memory command on that router show the memory left for processor is 367MB. Also the free memory is app. 53.8MB, wh...

Hello,       I have been trying for several days and have downloaded different IOS but to no luck. Can't get this AtoM to work on my Cisco 7206. I am just wondering if someone can tell me which IOS should work Following is my configuration output.The...

I have setup pbr to direct traffice to a particualr interface but it's not working.I have the following config:interface GigabitEthernet0/0 description $ETH-LAN$$ETH-SW-LAUNCH$$INTF-INFO-GE 0/0$$ES_LAN$ ip address 172.24.201.190 255.255.0.0 ip nat in...