Hi NetproTo have redundancy at Branch we opt VSAT link.Two WAN Links will terminate on different Routers. HSRP & GLBP are options. Can Expert advice with tips and share experience on subject.
Hello,Looking at the diagram attached, its a pure IPSEC over GRE Tunnel.All Branches terminates at HQ and working ok. All Branches access Oracle, Email, JD-Apps, Intranet server from HQ over the tunnel on 8MB link only.Now struggling to configure PBR...
I have a 1841 on which i am terminating my ISP link, fortunately i have two IPS in that link . All the traffic is routed via one Static IP, what i want to do now is to create a particulat inside pool to access a particular outside pool using the seco...
Hi experts, pls suggest any example or configuration commands for LL and ISDN config on router.ISDN line is for redundancy.pls give any link also ,Thanks
I'm having trouble figuring out how to set up an AT&T OPTEMAN EVC in my home lab.Routers r1, r2, and r3 are connected to r0 by way of the OPTEMAN circuit but they're also connected r1<->r2 and r2<->r3 by the same OPTEMAN circuit. I'm imagining I can ...
sorry i have also posted under security by misake!I am planning to change VTP mode from server to transparent on 2 switches linked via L3. The switches also have indirect layer 2 link via trunking between 2 other switches! (sorry no diagram). VTP adv...
thank you first.4 routers:R3--R1--S1--S3R3 and R1 are in Area 3;R1 and S1 are in Area 0;S1 and S2 are in Eigrp;redistribute S3 Lo0 into A0.When show ip ospf data on any of these three routers that run ospf, there is only type 5, no tpye 4.why?
Hi,Implemented MPLS VPN, however struggling with voice service. We have creted one common services VRF where all the services are teminated.Imported all other VRF routes into this VRF and vice versa. However the customers in diferent VRF's cannot cal...
Hi NetopsCan Two Internet links be terminated on same interface. I got 2621 with 2FE. 1FE is connected to BBSwitch and another to Internet Broadband Modem. Default Route is pointing to service provider GWIP route 0.0.0.0 0.0.0.0 192.168.1.10
Hi,Just wondered if anyone can assist with this as it's a urgent request from our customer.Basically, we have a site with 2 x 34mb WAN links. The links work as traditional Primary / Backup so all traffic (e.g. 192.168.0.0) is routed in/out of the Pr...
We have a remote site with a Cisco 1841 router and ADSL WIC. We would like to migrate to a 10Mbps fixed rate circuit (ethernet presentation) instead of the ADSL line.Since the 1841 comes with 2 FastEthernet circuits (and we currently only use one of...
Hello,We're moving towards BGP, got ASN from ARIN recently. Currently we are in MHSRP in two routers and policy-based route to any of the link from certain source/destination traffic.Let's say, currently we have two public network id from two provide...
Hi all,Please refer to attached diagram.R2 & R3 connect to R1 via E1. R1 LAN public IP address is connect to Internet router.Host with private IP at R2&R3 LAN need to access to Internet.I wolud like to make the R1 as aggregate router, where it route ...
