Routing

Hi, I Have several subinterfaces configured in GSR closing the connection L3 in some BRAS (connection point-to-point). But after everything configured with itself ping in some interfaces and other no. Did some already catch this problem, will it be t...

Hi All, I want to configure VPN over ADSL link in c2800 router, the challenge here is i am having ADSL link at both the locations with dynamic IP from ISP, Secondly i have fortigate firewall already running on the same ADSL link with dynamic ...

I need to track a static route with IP SLA in order to facilitate a backup connection. The static route needs to use the next-hop learned from the DHCP provided default route.I know I can track the DHCP provided default route but that doesn't help. T...

Hello,I want to my use Cisco 878 Router as a Bridge and want to make the PPPoE authentication at my different brand firewall. is that possible ? thanks for your all comments.

Hello GS,I am looking to configure Redistribution between EIGRP & BGP Protocol.Current scenario:-Core Switch: Only configured with EIGRP for ATM 2MB link.WAN Router : Configured with EIGRP for ATM link and BGP for MPLS 10mb link .Due to this All Traf...

HiI have one small location 20 users are there the long of the location is 70 to 100 KM.I have cisco 6500 core switch I want to put 3750 access switch to the remote location.Please advice me what Gbic shoul I use ? will it support 6500 SFP 24 port mo...

Is there a way to limit the sessions on ip basis or something else? And can we also apply time ? I mean at night the QoS is removed.Thanks

Hello,I am seeing the following error in in my router which is configured with EIGRP Protocol.Can any one tell me what are these logs about.Sep 29 00:41:56: %DUAL-5-NBRCHANGE: IP-EIGRP 1: Neighbor 10.3.250.18 (GigabitEthernet13/24) is down: retry lim...

Hi,I have MPLS link between India and US. I have configured BGP. Beside this, I have created GRE tunnel on these two point and publishing few EIGRP routes on GRE tunnel. The problem is whenever my physical link on India side is down, it shut down the...

Dear all,a basic question can i use the listed ip schema for to different networks or i have to be subnet specific for network s wise10.80.10.129-10.80.10.158 255.255.255.224 10.80.10.161-10.80.11.30 255.255.255.128

Dear Sir,we are facing problem with redundancy for our two internet links, We have 1hsdl card installed on cisco 2811 router and create bvi interfaces for connectivity, while tesing with ISP we had made below obervation:-when I am shutting the bvi1 ...

Hi,I am trying to find best & least expensive way of connecting one of the sites with our corporate HQ for the purpose of data transfer via FTP. the file size would be around 500MB.Our HQ is having an MPLS cloud connection. but this remote site doesn...

Hi. Please understand my poor english. - OSPF Network link1 +----------+ 10.2.2.1/2410.1.1.1/24 R1 + + R2 +----------+ 10.22.22.2/24 link2 - R1 have network 10.1.1.1...

- What is the effect of removing the SPAN session used by the FWSM installed in the C6513 switch (no monitor session servicemodule).- Is there an IOS for the 6513 switch that support configuring more than two SPAN sessions on the switch? As the switc...

Gurus,I have this setup on my network;ClientA-EBGP-MyRRCllient-ibgp--R1--ibgp--R2Will ClientA advertise routes be received by R2? since R1 recieves this thru ibgp but an RRClient.Thanks.Jeff