Routing

I have an 871WSite to Site IP_SEC VPN is set up and working with a remote Linksys BEFDX41 router.Easy VPN Server is also set up and workingProblem :Traffic from the Remote site over the site-to-site VPN works BUT if I add a static NAT entry on the ...

Hi,Can Cisco router be the IPv6 DHCP Server? I have read that Cisco router can not be IPv6 DHCP Server... just want to make sure...regards,Devang Patel

In my lab BGP does not advertise connected routes unless I add a network statement. Is this the default behavior?

Hii, Want to confirm the following from you :-1) What are the different states of EIGRP. What are the function of each of them.2) What is the default metric while re-distributing BGP into RIP.Regards

HI i have configured HSRP between the two router and all HSRP states are working fineonce i applied and access group on the interface for the incoming traffic now HSRP states went to Active on boths side interface FastEthernet2/1 ip address XX.90.225...

HelloI have 2 routers (A and B) with 2 tunnels (1 and 2) between them. OSPF is running and tunnel 1 is favoured due to a better metric. Router B has a route map on it's lan interface. This directs specific traffic to tunnel 2 - Host X to Host Y (rou...

I have SPAM problem whenever we try to send email via Outlook the email immediantelly returns whith the error below:Your message did not reach some or all of the intended recipients. Subject: Voice Destination - Sudan Sent: 9/30/2009 9:49 A...

Hi all,The router comes with IOS c2800nm-adventerprisek9_ivs-mz.124-24.T. This router default with 2 x gigabit ports.The sh ver shows 3 Gigabit ports the extra port from NME module. The issue are as below1. All the NME fast ethernet ports (Total 23 )...

Hi, I have initiated Traceroute from my Router & am confused with Tree times msec in the reply with each next hops. Please guide me why three times Msec is there for each IP and what is its mean?Router# traceroute 208.11.11.1051 200.22.22.111 60 ms...

Hi,what is the best way to measure the bandwidth, packet losses, jitter and delay between two systems over IP network?ThnksAnas

I need opions on best options to control bandwidthwe have an OC3 ATM with a 20Mb PVC connecting to Qwest MPLS cloud in our main data center. All endpoints connect into this MPLS cloud and all have full t1 access. We discovered today when someone wit...

Hello, Users of our LAN back worries slow in using the SAP application. By analyzing the network I did not find particulary problem: No CRC, no collision. I want a methodology for analysis of cisco response time of an application