Routing

Below is the config applied...what am I missing.They are telling me that they cannot connect to the remote end.I am running BGP on this router with 2 E-1 connections and I am peering with ISP's loopback.Please see attached config.We currently send al...

Cisco's documentation on the 2600-series indicates that the NM-4T1-IMA card is supported in the 2651XM router. I cannot seem to find an IOS version that supports it though. The Software Advisor tool always times out when I use this hardware config....

All,There's not a problem running frame encapsulation on a vWIC2 correct? I've got a situation where we're upgrading all of our 2500 and 2600 routers in the field that are using external CSUs to 2800s and we're wanting to use vwic2s in place of the e...

Below are my questions:1. How to determine the acceptable latency, througput in accessing an application over a WAN infrastructure?2.How to set threshold for a certain application traversing WAN that is accessed by multiple users?3.In capacity planni...

I had the next configuration in pix 7.24, the peer is firewall nokia:access-list vpnxxx extended permit ip host 1.1.1.1 host 10.10.10.7 access-list vpnxxx extended permit ip host 1.1.1.3 host 10.10.10.7crypto ipsec transform-set tranxxx esp-3des esp-...

Hi all,How to erase startup config on CRS device running XR version? Write erase command is not there...How to erase all my running / start up configs to make it as a fresh box.Please help me....

HelloThere is LAN segment with R1,R2,R3 running EIGRP. R3 is configured as stub. R1 and R2 are connected to other LAN segment. R1's connection to that segment is goin down. R1 send update that it has no longer that prefix. R3 receives it and let's as...

Hi,I've set up a site to site VPN to an ASA at a branch location, but the remote site also needs local/private DNS. I can't get the remote LAN to use DNS servers behind the VPN, because there's no network redundancy and if the VPN dies, the site has ...

I am trying to get a hardware VPN up between a Cisco 2650XM and a Multitech 820 router. Is this something that would be possible using IPSec and 3DES or AES-128? I'm new to the Cisco VPNs and if this is possible how would I go about programming the...

Since this doc was update back in Aug 2005 (see urls bottom page), I wonder if there is a current workaround since then.http://www.cisco.com/en/US/tech/tk365/technologies_configuration_example09186a00800945bf.shtml#conf5Basically, I have the same AS ...

Looking for sample configuration on 2 ISP Link Load Balancing on 2800 Router.Router with 3 FastEthernet, two of them connected to ISP and third connects to LAN

hi friends,how can i configure the two CISCO VWIC-1MFT-E1 ports into single channel group serial interface.i need both ports to work as one data pipe.