Routing

I have one router 2600 dialing into my hub 7200. The call keeps disconnecting every split second. The only change was the ISDN lines were reordered. Here is the debug q931 info. Any help would be appreciated.

I have multicast set up on my LAN using vbricks.I want to extend use of the vbricks to another site. To get to the remote site, the 4510 connects to a firewall locally, then hits the other firewall at the remote site, then to the 3750 user switch. ...

The question is How do I mark 1918 traffic so my vendor can prioritize this traffic over 1918 traffic without messing up my voice traffic?We have MPLS connectivity where the Public and Private (Voice and Data) traffic travel across the same WAN link...

Hi,I have two remote networks connected via fiber link provided by the servvice provider.the WAN devices is 3750 switches, so fiber link that is comming from the provider is terminated on 3750.my contract with the provider is 500Mbps as a bandwidth.i...

Hi,We have two 2821 routers in two different locations. Both these locations are communicating using leasedline. and the propotal using is EIGRP. Now we got a framerelay link at both these locations and we are planing to keep this link as a backup li...

Case:Consider EIGRP Configured on both routers.EIGRP decide which link is successor and feasible successor depending on its own parameter calculations.Parameters include Bandwidth, Delay, Load, Metric, Reliability, and Advertise Distance. Here are th...

Hi all,I'm involved in a WAN redesign at the company I work for and I'm seeking advice regarding the equipment we're thinking of getting.Topology of the WAN will be dual-hub and spoke with both hubs being active. Half of the spokes will connect to on...

Hi Everybody,I have configured IP SLA monitoring to probe the reachability of the peer and it is working perfectly. I have 2 ISPs configured in the same 1841 RouterBut when ever there is a change, that is when the remote peer is unreachable the trafi...

Greetings, Please refer to the attached diagram. Basically i have a remote site with dual connections and i want to be able to load balance outgoing remote site traffic going to serverA. The problem here is that i cant run a routing protocol from the...

Hello and PLZ Help MeI tried to console to a VPN C 3005 using RS 232 cable with 2 DB 9 Female at both side (PC/SERIAL)-(VPN/CONSOLE) and Tuning Terminal Settings as Cisco described although I've attached to cat 5 cable to each interfaces (private-pub...

Hi,i can`t find information about capability of cisco 871 router. cisco871-sec-k9 v05. Version 12.4(15)T7.ISP give me a username and password to connect to ADSL line. Is this router capable to connect?Thanks.

1. the customer has two wan links need:when the traffic on link no.1 reach thershold level the traffic must go by link no.2if it possible how can i make this configuration

Hi,I have successfully used the local filtering capabilities of the 2811 router to setup a filter to block from different subnets or even within the same subnet depending on IP via the zone inside to outside type of policy.The issue I am having is th...