Routing

Hi Experts,I m doing policy-based static NAT with the following scenario.R6----| |---R4----------Serial---------R5 | -------- FR ----------- R1----|R1,R4,R6 are on common Ethernet of subnet - 10.0.0.0/24 . R4 to R5 on serial link subne...

My solarwinds is reporting tx discards but the sh int mu x does not report any errors. Is there a command that will report the tx discards?

Hi NetProsIf we have two different leased line links from two different service provider and they are reaching to my remote branch network from HQ. Network looks as below. R Router1--isp1--R1--core sw1---HQR Router1--isp2--R2--core sw1---HQMy questio...

How can clear counter that generate the command "sh policy-map int"

Have you ever seen where a Cisco router "lose a command line and then will not accept a command line?First of all, before rebooting a 2801 RTR I wrote the config and then rebooted the router.After the reboot we started having incoming email issues. ...

Hi Everybody,I am configuring and testing EIGRP. I facing instance as described below:I have 3 Router configured as shown in diagram runing EIGRP.I have 3 Subnet 172.16.1.0 / 24, 172.16.2.0 / 24, 172.30.1.0 / 24 in Router A1. When I configure "no aut...

interface Serial0/2:0 bandwidth 1544 ip address x.x.x.x encapsulation ppp ip ospf network point-to-point ip ospf cost 9999 ip ospf hello-interval 15 no fair-queuecan I do a loopback on the interface to trblsht the T1 line w/ out having telco involved...

I have a block of IPs from ISP that are currently in use. I have received a second block of IPs for additional use. However, I need assistance in adding new route to allow my current network to communicate to new IP Block.

Pondering if it is a good idea to load balance between two ISP for our internet connection. We will be using bgp with default route and utilizing our own IP range.Both ISP connections land into a single router and behind it is a ASA. All inside traff...

Dear all, I am facing Problem with C2960 Switch that I could not able to take console to it. And also I given default COM Port Settings.

Hi Experts,Need your help. I have configuration as below AND ALSO debug log at the bottom. NO matter what I have done , I still cant get it up.- I have username/password of the other end router configured.- I have the dialer protocol permit ip listI ...

I am trying to NAT my inside local address to outside global. MUST I assign an address from the inside global to an interface before it works?

Hi,I read that by default there are different Tx Queue Sizes for different queues available.1. Can we change the Tx Queue Size of Priority Queue ?2. I guess we can change the Tx Queue Size of Standard Queues by <<wrr-queue bandwidth X Y Z >> comman...

Static Route:ip route 10.10.10.10 255.255.255.0 20.20.20.20If router cann't ping 20.20.20.20,but output interface fa0/0 is up, is this route item also in routing table?