Routing

Hi Folks - I have a Cisco 2821 router that I will be using for terminating multiple T'1 using MPPP. The total number of T1's would be 6. The 2821 already has two vwic2-2mft-t1/e1 cards giving me a total of 4 T1 interfaces. So if I order WIC-1DSU-T1-V...

Hi,My server(10.194.35.16) has to communicate to my client(10.194.90.15) over multicat address 239.255.0.127 udp port 8192.I have enable ip multicat on all the interface on the path as below,""ip multicast- routing"on int "ip pim spare-dense-mode"The...

Hi I would like to use VWIC2-2MFT-T1/E1 card on cisco 2811 to connect 2 T1 lines and acheive full 2*1.54 Mbps of link speed. Wanted to know if there is any concept of structured & unstructured T1. What is it generally provided by a carrier in US - st...

I have a problem where I have branches connecting to a 7206 router.From the stores I can ping 4.2.2.2 without a single packet dropped. However when I try to ping through the tunnel I get about 6% packet loss.when I ping from my internal network to th...

If I have 10 locations having a single T1 which are PVC's and two locations which are DS3's PVC and at 10Mb. By using Adaptive Frame Relay Traffic Shapping, would I be able to, when congestion is high between the two sites with the 10Mb link, realloc...

If you have (failover) senario where adjusting the arp cache timeout on a router interface (from default of 4 hours) could prove beneficial is there a recommened minimal threshold to not go below in seconds?Thanks,Brandon

Hi all....I have two CISCO 2811 routers connected. I have two Metro-Ethernet links between them.I've configured OSPF and when one link goes down, OSPF send all traffic through another link. That's working fine.But my problem is, when one link is poor...

I am trying to change where I redistribute static routes from. I have attached the diagram of the environment I am testing this with.Currently I have a static route on Switch 8: (ie. ip route 5.5.5.5 255.255.255.255 10.0.20.4 ) which is then redist...

Can anyone explain to me what are the keepalives for? Do keepalives work on layer 2 or are they used on layer 3 routing protocols like EIGRP and OSPF. I am asking because OSFP for example uses dead intervals so what would be the point of having keep...

folksi'm looking for a guide to configure a router to authenticate user credentials passed in from a NAS once authenticated i hope to allocate users an ip from a specific pool (one for each user)thanks to anyone taking the time to reply

All,If running OSPF over MLPPP, will the cost increase if one link in the bundle fails?Thanks,

I'm not that schooled on access lists at the moment so I need a little help with a configuration.I want to deny all access to a specific interface except to allow http traffic.interface that routes out to the internet is interface FastEthernet0/1 65....

<p>Hi Gurus,</p><p>Im having trouble on my policing and shaping on my 6509, its not working. My mrtg shows they exceed their limit.I dont know if its the ios, here's the version. IOS (tm) c6sup2_rp Software (c6sup2_rp-PK2O3SV-M), Version 12.1(20)E, E...