Buy or Renew
Buy or Renew

Routing

cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation

Labels

Forum Posts

Start a conversation

Set dialer in a Cisco 2800 Series

Hello Folks, we have a problem when i try to set a dialer connection in a Cisco 2800, series.When i set the type of encapsulation in the interface bri it appears this message:"Encapsulation not allowed on voice only interface", what does it mean?, i ...

Sitov1982 by • Level 1
  • 971 Views
  • 2 replies
  • 0 Helpful votes

Flat vs. Routed network

All,We have 3 buildings that are side by side. We have a fiber run between two buildings for a switch to switch connection (bridged), and we have a P2P T1 to the other location on a routed network. Ok, so we are going to try to phase out the T1 at th...

Resolved! Policy Based Routing on ASR1006

I have run PRB on multiple Cisco router 2800, 3800, 6500 etc. We use it for redircting to a WAN Accelerator. We setup the ASR the same as all our other with a route-map and an match criteria of an ACL and added the "ip policy route-map" statement to ...

tfbissett by • Level 1
  • 787 Views
  • 2 replies
  • 0 Helpful votes

Channelised STM.

Dear Freinds, I need to configure Channelised STM on Cisco 7613 Router (7600-SIP-200) 1 Port with respect to E1. Requesting to please guide me or share config.Regards

DNS SERVER with public IP behind the router

hellooi want my DNS server to be accessible to the internet , ok i have poll of pulic ip address, and i have the router with serial interface configured with another public ip , i want to assign my server one of those public ip should i configured th...

alaeldien by • Level 1
  • 865 Views
  • 3 replies
  • 0 Helpful votes

Resolved! Help choosing the appropriate router.

Hi guys,We are int he process of upgrading our WAN to higher speed data links back to our head office.We have a number of remote sites, which we be getting either 4Mb/s and 6Mb/s data pipes (over the carrier MPLS network) back to head office.At the m...

it by • Level 1
  • 1092 Views
  • 10 replies
  • 0 Helpful votes

Bandwidth segregation (Help)

Hi,Customer is having network topology like this,Customer is having 2 Mbps link from Service provider which is connected to PIX,Customer requirement is how can he alocate bandwidth to 3 Departments using current setup....Note:One Department will requ...

bagvanliju by • Level 1
  • 3533 Views
  • 11 replies
  • 0 Helpful votes

Measure Bandwidth

Hi,we have upgraded our Internet Bandwidth from 256Kb to 2MB ; what tool or command can help to know if the bandwidth is really upgraded to 2MB.Our ISP is in the same premises so we have Ethernet-Cable from them terminated on Router at our end.

frame relay over satellite

have project consists from main office and nine remote sites will be connect through satellite links i am thinking to use Frame relay Hub ans spoke i will use Cisco routers, but i have problem , bcz i am using Satellite link; at the main office there...

Migrate branch from 16 bit subnet mask

We have our remote branches set up in a 16 bit mask configuration.I would like to move this over to 24 bit and isolate everything in seperate VLANs.We have Cisco VoIP for each branch with Call Manager in the Main site branch.Currently the switch is c...

Load more