Routing

HiI have 8 E1 line to connect another site.I configure multilink and get bandwidth 17 Mbs. but suddenly when 1 e1 is down then total link is down but show multilink is up. i can not ping connect site. when i pull out the faulty e1 then again connecti...

Hello,I was hoping someone could assist with providing me details or perhaps a link where I can find the default configuration settings of the WIC-1DSU-T1-V2. We are trying to determine - the out of the box - default behavior of this module and what...

hi,where can I download SDM ?I need it for my Cisco 837 ?best regards

Hi,First Happy new year for 2009.I have a Catalyst 3560-48PS-S in 12.2(46)SE IPBASEK9 IOS and I can't apply a "service policy-map input" on my L2 IP Phone FastEthernet ?This syslog is displayed :%QOSMGR-4-CLASS_NOT_SUPPORTED: Classification is not su...

I Guys, Is there someone who can help me on how to run a Ghost server in my 3500xl switch. Thanks,Jong

I have a site running EIGRP that has two possible gateways. Currently, one of the gateways is a 10MB PTP that I want to use as the primary.I have a 1.5 MB PTP that I would like to use as a backup (only if the 10mb fails). Here is my question - I pu...

I have an ASA that can't ping ip addresses that end with an even number. For instance I can ping 4.2.2.3 and 4.2.2.1 but can't ping 4.2.2.2 I've tried with different ip addresses but it's always the same result. Any ideas?

Hello,For the most part I understand the purpose of clocking. The majority of our circuits are Sprint MPLS and the clocking is derived from the line.What I'm confused about is how to configure clocking on a pair of routers that are connected to each ...

Hi ALL:My switch is in rommon and i dont have opton for xmodem and tftpdnldso i tried to boot the switch from the ios on tftp,but when doing that i am getting the following errorany idea whyi have tried Bothrommon 86 >boot tftp://192.168.112.7/tftpbo...

need 12mbps on WAN. Would it be best to do 12 PRI's and do MLPPP to remote 18 sites or can I have NM-1A-T3/E3 module to support MLPPP to these remote site that may have 1 or 2 PRI's off a VWIC2-MFT module? THXS for your quick responses

Multilink in 7609 Router, in that 3E1 links are connected in PA-MC-8TE1 Card and 3E1 links are connected in STM 1 Card. This E1 links are not working properly when configuring in single Multilink. Individually links are working fine and with seperate...