Routing

Hi..I seem to have a problem with the stability of my wireless infrastructure. The problem seems to be that the APs Disassociate from the controller and associates again after a while. Sometimes I even have to reset the APs to re-associate.The only h...

Hello,I have branches connected with VPN and I wanna guarantee bandwidth for that traffic using the following configuration:!Access list to mark internal trafficip access-list extended QOS permit ip any 192.168.0.0 0.0.255.255!!Class-map to mark inte...

Hi,I am having this issue when ever I apply the encryption command on the WAN interface and I can SSH into the box when I remove the crypto map command.I am getting the following message if I try to access the remote router from our management box. 0...

I have been doing some reading here for wake on Lan, and followed some of the directions that has been posted here, but Im still not having luck. (I also started a thread a week or two ago, but cant find it now?!?!) Anyway, I have a PC in one locatio...

Currently we have a network that is not physically seperated but seperated using VLANS. Servers and workstations are in a VLAN, IP Phones are in a VLAN. We host a web application for our customers and we would like to seperate the servers that host t...

I have a problem I hope can be figured out here. I need to transport proprietary Ethernet frames across an IP network while still routing IP packets on the same interfaces. It looks like IRB will do the trick but I am unclear as to how to get the bri...

There are two ways for configuring QoS that accomplishes the same thing. I have configured both methods and both work without any issues.I would like to know from the two simple examples below, which one if more recommended and why???Method 1: Class...

Dears ,I do a policy-map like below .what it will do ? I want my traffic to limit to 32Mbps with less effect to the customer . policy-map 32Megd class any shape average 30720000 police 32768000 conform-action transmit exceed-action dropRegardsHa...

I've got a couple of questions about MPLS:What is the difference between LFIB and LIB? For some reason, I keep confusing these.Thanks!John

we have the below networkisprouter1------switch 1------cus-router1isprouter2----switch2---cus-router2switch 1 and switch 2 are interconnectedcus-router1 one ethernet interface is connected to LAN siwtch 1 and cus-router2 one ethernet interface is co...

We all know that traffic shaping enables us to burst traffic of a value Bc during Tc interval (if no Be configured of course) and that it retains out of profile packets in a queue till it have enough tokens to send more pakets and the question is , ...

Greetings, i have noticed recently that when our 2Mbit/s E1 link is fully utilised Jitter and Average Jitter increase to ~30 - 60 as viewed from a 7941G handset, when the link is idle both these values hover between 0 - 5.Now we arnt having any voice...

Can any of you pros direct me to a set of books or references that you have read or used that has help you understand the WAN, I'm a student and taking courses for CCNA

Are my eyes working? Is the BSCI exam retired? I just passed it 1/16. How can someone be NP in routing and switching without knowing routing protocols? Did I just take an unnecessary exam? Why is it still listed in the composite? Why would someone ta...

Dear ALLI want to implement T1/E1 mode on SHDSLmy card is wic-1shdsl-v3 on ciusco 2821 with ADVENERPRISE IOS.I put "no mode" on controller-config prompt.after reload there is no option for "mode e1" there is just "mode atm" available.why is so?