Routing

Hi, i would like to inquire what commands should i look for in our router to know if we have load balancing? i am not familiar with the configuration and just about to read in cisco - basic load balancing page would be appreciated

Hi, is there any way to assign ip for nhrp spoke tunnel interface dynamically from the hub?I'm talking about that scenario:http://www.cisco.com/en/US/tech/tk583/tk372/technologies_configuration_example09186a008014bcd7.shtml

I am searching for a Router to connect a branch Office with 3 Desks to our Headquater via a PPTP Tunnel. The Router has to create the VPN Tunnel to our Windows Server based PPTP Server. The 3 Desks shall be able to access Headquaters Network through ...

Hi,I have couple of back to back serial interface cables for connection between two Routers. When I tried for two routers for the below said configuration the line protocol is fluctuation intermittently. Please let me know any additional configuratio...

What's the best way to troubleshoot lag? Our main router that connects our sites is giving ping times from the inside of 300ms. The processor is at 5%, and the memory stats are fine (about 40% free). The tx and rx is about 50/255 (or about 20%). Teln...

Imagine I need to place 6509 switches in a MDF room which is 20 ft. away from a 480V transformer. Which is level of EMI a network switch like that can handle? Any ideas on how to I determine whether the transformer is in fact could cause EMI and inte...

Hi all. I was wondering about some potential security issues on MPLS, MetroE, T1 etc. My thought is that there are companies that provide these access and that someone who might be a little devious might want to play around a little and sniff "from...

Hi All,I have a 1811 that is used to failover between 2 different WAN providers. One Cable and the other DSL - works well. I now want to aggregate the available bandwidth from these two and use all that is available. I want to allow a bandwidth thres...

I have 3 servers in a groupowner RODSWeb content RODSRE add service PRDODS3 protocol tcp port 80 vip address 172.20.230.10 add service PRDODS add service PRDODS2 activeHow do i verify that each server is getting hit equally? or ...

Hello Experts - Firstly thanks for the patience involved in answering my questions. I've only recently started working with our 3825 gateway and I am hoping to gain more understanding, and my coworkers are not able to answer my questions. I've studie...

Hello Experts,We are experiecing serious issue with the EIGRP Protocol.We are running a LAST MILE Routing protocol as EIGRP between the PE - CE Router.The EIGRP resets every 60 / 120 seconds for all locations and in the DEBUG the message that i recei...

can i change ospf update metric using route map? note i have one ospf instance.the configuration:router ospf 1 log-adjacency-changes network 10.1.1.0 0.0.0.255 area 0 network 33.33.33.33 0.0.0.0 area 0 distribute-list route-map cisco inroute-map cisc...