Routing

Hi,We have 4 T1 circuits which are bundled into ATM/IMA group.However, I found the guy set first two interfaces have weighted fair as the Queueing strategy, and last two have Per VC Queueing.I think the grouped interfaces should have same queueing st...

I currently have a Cisco 2600, IOS v12.2(5d) with one WIC-1DSU-T1 interface card. I'd like to upgrade (or add, depending on what the carriers says) this circuit to a T3. What interface card would I need to add? Thanks in advance for any help.

I have a client with an Cisco2811. He now wants it to be a POE Router. Can he update the power supply and network module to make this happen or does he need to purchase a cisco2811-ac-ip?

Hi all, I received the below log message on my 1841 with regards to my 3G Wireless HWIC. I have tried searching for a definition of the message but have been unsuccessful so far. If anyone has any suggestions on hwere I can find the meaning/cause of ...

PBR is not functioning correctly. Here is the configuration:ip access-list extended PBR10 permit icmp any host 10.1.2.3route-map PBR permit 10 match ip address PBR set ip next-hop 172.16.251.1interface FastEthernet0/0.2ip policy route-map PBRScenari...

Dear all,Kindly i want to know some information about the following module that will be installed in Cisco 3845 ISR router:VWIC-2MFT-G703Does this module support Channalized E1s and How many Channel groups support in each port?i tried in cisco.com bu...

Hi Folks,I have a doubt regarding the use of ECN with WRED.R1 ----- R2if we have 2 routers R1 & R2 connected on a FR-link.we have confgured a policy-map on R1 with a class-map for FTP traffic. this class also configured with WRED(ECN enabled).policy-...

I've inherited a MPLS network and haven't used it before. On the MPLS router that is in my Home Office there is only one interface. Should that be setup with sub interfaces for each site or am I confusing Frame Relay with it?So for example the curr...

We currently have one Internet gateway. We are adding two more. I need to publish these additional default routes into our BGP cloud (we currently use default information-originate to publish the current gateway) and have certain sites use them in ...

I have one 2600 Router and two ISP with 2Mbps each pipe. and it is connected via serial interface. As of now, i just created two default routes, one with AD of 0 and one with AD of 10. Is there anyway that I could use those two links at the same time...

I have two cisco routers connected via leased line ,suddenly the cpu utilization became 99.9% ,the show processes cpu gives high utilization for "encrypt proc" process???what this means???!!!!

Customer with 12 1700 switches across a WAN, that connect to a webapp served by IIS. Every Monday the remote sites have no access (404) to the Webapp, and we have to reboot the switch. The remote users can ping the server, and LAN users can access th...

Hi,during an FTP from Fa0/1 to Fa0/0 on a 2611XM the CPU goes up to 94%/92%. During this time ICMP packets through Fa0/0 per-packet load shared S0/0:0 and S0/0:1 get dropped. I do not yet know where the ICMP gets lost but if anyone has an idea what p...