Routing

Hello All, My AS-2511-RJ recently starts hanging while in the middle of work even when restarted and pressed enter has demanded, it hangs thereafter as you can you from the output.Any help to alleviate my service obstruction shall be greatly...

Right now I have 1841 with an IP BASE IOS, major release 12.4, release number 12.4(1c)Now if I want to upgrade the IOS to the 'Advanced IP Services' feature set, do I need to get the one for 12.4(1c) and only that one?Because I do not see the Advance...

Hi, I have 3 routers set up in this lab (see diag), the LAN at the bottom can ping router R3-2610's ethernet port at the top, but not the SE0/0 port. Now R0-2610 and R1-2610 are using RIPv2 and I have not added any dynamic routing to R3 yet, what wo...

Gurus,Im announcing a default route on my client and i got this on the remote side .r> 0.0.0.0

HI All,, I have ASA5510 at 3 sites, each site has internet link on first port e0, LAN connected on second port e1, and MPLS b/w all 3 sites on third port e2, Now i have also created site to site VPN over internet on all 3 sites. I want to achiv...

Dear All,I have core 6509 switch in our data center connecting to 7206 router with gig interface both the sides. I am observing output drops occuring on switch end and the drops are not occuring continuesly, its happening intermetently.Both the sides...

Hi,during 1 of the troubleshooting i found that there are high number of collisions in my WAN interface.And it caused the IP phone can't get registered in my HQ's CCM.But the phone will back on after 1 day or few hrs later.Is it due to duplex mismatc...

hi,i have configured FTP server in DMZ zone of the ASA server. i have two public ip addresses a.b.c.d and e.f.g.h when i configured FTP with a.b.c.d it works fine for the inside users and internet users, but when i configured it with e.f.g.h it worke...

I am getting 8 Mbps of Internet bandwidth from Service Provider throuth 4 e1 ports and I have Cisco 2821 Router with 4 E1 ports and built-in 2 ports giga bit Ethernet. I want that all my bandwidth (8 Mbps) should terminate on my one gigabit Ethernet ...

We are implimenting a new subnet172.20.255.8/255.255.255.248172.20.255.9 HSRP VIP gw172.20.255.10 router A172.20.255.11 router b172.20.255.12172.20.255.13172.20.255.14 172.20.255.15 I have configured the .10 address as a secondary IP address on on...

Dear experts,Can any body tell us what is ADHOCK networking plz give me any documentsfor adhock networkingThanks&Regardssrini

The 1-Port Channelized STM-1/OC-3 Shared Port Adapter data sheet states that it supports: Up to 84 T1 (or 3 T3) or 63 E1 (or 3 E3) portsUp to 1022 nxDS-0 channels (where n is 1 to 24) with no T3 configuredUp to 400 nxDS-0 channels (where n is 1 to 24...