Routing

Hi all,I'm looking for some info from people who have deployed these types of cards. We have need for a wireless backup on a 2801 router that terminates a T1, but does not have Cable or DSL in the area. We tested a satellite link, but the latency is ...

Hi,Does anyone knows how to run GRE Tunnel over IPSec. The scenario is bit different. Let me try to explain. PE1 and PE2 belongs to ProviderA which is basically public Internet. PE3 and PE4 belongs to ProviderB which runs IPVPN private network. CPE(...

Hi,I am working on running OSPF over PPPoE, It works fine with DHCP pool with /24 subnet but with negotiation as client is getting /32 ip address its not working because client and server are at different subnets... so what to do to get it resolve?re...

Hi,I have a Unframed E1 on Cisco 1841 with VWIC-1MFT-G703 card. Can WIC 1T card be used to replace the VWIC-MFT-G703 card ? WIC1T supports Unframed E1 or not..?Thx,Gaurav

If a router has multiple routes learnt via EIGRP and those routes have the same cost, which route is used ?

Hi,i want to know is ther any LINUX based Router which can support IEEE 802.1Q to perform VLAN's,I tryed with Zebra which is the Linux based Router but it dosen't support 802.1Q for Inter VLAN Communication.can any one help me i just need a LINUX Ope...

I have two Catalyst 4507 as core switch. They are uplink with each other on redundent fiber cable. I am also running HSRP for each vlan configured on it. Everything was working fine. But this morning suddendly communication stop. No response of telne...

I want to configure port monitoring between two ports on cisco 4506.but its not working.configuration:monitor session 1 source interface gi3/16monitor session 1 destination interface gi3/16sh monitor:Session 1---------Type : Local Sessio...

Can I configure HSRP to run between two ports on the same router? I want to implement port level Layer 3 redundancy. Typically this is done using two different routers (better) but we have a single router. I have 2 HWIC-1FE ports that will be conn...

we're thinking about using these cards for few remote sites for internet serviec? Has anyone used it? How's the services? and which carrier is good as far as providing coverage and high speed? Whats the highest speed that we can get out of this?Thank...

Here's my topology:Site A in NewJersy, USARouter1 EBGP to primary ISP1 with AS1Router2 EBGP to backup ISP2 with AS2Router1 and Router2 also have an IBGP with public AS100 number to each other as well as using GLBP for loadbalancingNew Site B in Londo...

In my cisco callmanager4.2 environment,one 7940 ip phone located in remote branch ,connected through leased line.Now i facing issue with no voice stream after call is connected .I checked the connectivity and its ok.No firewall is blockig RTP stream...

Hi,I am going to start a design of IP/MPLS backbone with three P routers & three PE routers. I wish to enable L3VPN, AToM & VPLS on a single backbone. What are the possible issues in this solution? What are the recommended routers for this? budget is...