Routing

I have an application that will require multicast to work. I wanted to set up a test so that a thin client at a remote site could send multicast traffic to our Home Office. The Home Office router is a 3825 and the remote is a 2851. Both are running 1...

I have a TAC case open on this but I thought I would float it here, too.IOSver advipservices 12.4.11Tplatform 7200/NPE-G1 I am adding a pdlm for sap-app on a 7200. when the pdlm is loaded (other than at boot time) some very bad things happen.The symp...

Is it possible to access the console port of a device via MODEM....

I have Cisco 7507 router on which previously only one multilink is configured and it is applied to four stm interfaces.Now i want to configure two multilinks and want to apply on bundle of two stm interfaces each.But when I created two multilinks and...

Hello I went to make route selection to 2 ISP with QOS and Policy BAse routing (PBR),like this :SMTP + VOIP + CISCO web site pass throught ISP 1 ,and the other traffic not selected (all the web) pass trough ISP 2,any idea to do this ( I have router ...

bgp connection is flapping and on checking the neighbor statstics we get following message - keepalive are termporarily in throtlle due to closed tcp window

Currently I have a FR network, consisting of 18 PVC's. I wanted to introduce some HA or Failover when one of the PVC's goes down. What are my options on a 2620XM? I do currently have a VPN solution, should IPSec/SSL be an option. However, I'm wonderi...

HelloTomorrow I have to configure HSRP between two Cisco routers and a non-Cisco firewall.The first router provides WAN connectivity, the second is for back-up reasons.The firewall Trusted port is for the customer LAN and the Untrusted I can connect ...

Hello Experts,Can you please advice on the Market Value current & future for CCIP vs CCNP.CCIP composed of:1. BGP2. MPLS3. QOS4. RoutingCCNP Composed of:1. Routing2. Switching2. ISCW4. ONTCCIP vs CCNP:=============In CCIP, BGP & MPLS are Unique Techn...

ISP just asked me to provide IMUX for T1 in the state. Can someone recommend a model also a WIC card to use with the imux for a 2801 cisco router. is there anything else i need to terminate the T1?

Hi,when using a more specific route-map static which includes ports tcp 25 iam not able to nat, no more traffic flows, when using static without tcp restrictions in the static command it works, but i only want to static nat some special ports.my conf...

Hi,Can I configure multilink PPP over two E3 circuits? Can the circuits be with different vendors i.e Verizon and BT or do they have to be with the same vendors.One side of the link will be a Cisco 3845 the other a Cisco 6500 with FlexWAN.Any advice...

Dear sir,2800routerfxs------point to multipoint (v.35)----2801 with fxs.we have central to different branch office locations In central 2801 with 8port fxs is there and remote branch also having 2801 router with 2 port fxs .Now we want to communicat...