Routing

I'm hoping that I can get your guys input or perspective on bgp load-balancing appliances. I'm talking about those appliances which claim to work with bgp to offer "smarter" outbound load-balancing. Anybody ever used any of these and can recommend ...

I tried following the info on this page but no use:http://www.cisco.com/en/US/products/sw/secursw/ps5318/products_quick_start09186a0080511c89.html#wp74383the above tutorial instructs to put the pc into DHCP and then open the webpage https://10.10.10....

Want to create vision diagram, We have a lots of different types of cat switches. Does anyone know which web sites I can find the Cisco real visio icons? Please help.

Hi, I am working on a back-to-back frame-relay lab enviroment. I have the routers configured but for some reason I can route between the two interfaces. I am using Wic 1DSU T1 cards. I have tried routing protocols, I can't do frame-relay map, etc ...

Hello,I have made 2 other posts about this issue and haven't gotten any good results back. Please someone help me, I don't think this is that complicated of an issue.I've got a regular house-hold DSL service with the modem set into bridge mode, so i...

Hi,i am trying to configure something i call STATIC PAT HIGH AVAIABILIY.2 wan links are terminated on 2811 router. these are the nat outside interfaces. I have an application server on the private (inside) of my router which needs to be available thr...

Hi Guys, I dont know this is right forum for sach kind of question if not then please tell me where to post this question. I am facing problem with 3745 series router after reload it goes into Rommon mode. I have checked the config register valu...

Hi, my question is can I have multiple actions in policy based routing statement. For example, I would like for the PBR first to NAT a subnet then send it to next hop. Here is my config.route-map WS permit 10match ip address 10set ip next-hop x.x.x.x...

Hi,My OSPF neighbors reset them selves, I want to apply qos for HELLO and SLA traffic. I want to mark them but not sure how much bandwidth I need to allocate for it.Can someone please advise or an approperaite estimate/config?Regards

Hi All,I'm trying to set up a VPN for a few sites and I'm testing how to get traffic from an ATM cloud through our switched network as seen below. In theory, it should be Layer 2 all the way from the CPE to the Test Machine.Test Machine on VLAN 903 (...

First of all thanks to everyone who can help, this is the situation: I have 2 6509's (6509 A and 6509 B) that receive a EIGRP redistributed default route from our core routers, this core router receives this default route via BGP from our "internet r...

Hi All I am trying to open a telnet connection on port 1998 to a Cisco 876 router (C870-ADVENTERPRISEK9-M) on the same network - 'connect failed'The source device is running W2003 server. The reason for my test, is to facilitate connectivity between...

Hi Friends, We have BGP enabled on our networks with SNMP enabled to trigger alerts in case of link up/ downs. What we observe is when BGP session goes Active (but interface is up), we do not get any alert from SNMP saying BGP status has changed. The...