Routing

Dear Experts,Please advice !!!!I would like to do,1- All the Vlan can access to IP 50.50.50.50 ( Internet)2- PC on Vlan 10 can access all the vlan and ip 50.50.50.50 but all the vlan cannot access to Vlan 103- PC on Vlan 20 can access only Vlan30 but...

Hi,I have a VoIP system which resides behind an ASA5505. I need to configure port forwarding of ports 10000 to 20000 to my VoIP system. The only way I can achieve this is by creating a static NAT of all IP traffic then restricting the ports by an A...

Hello All, I have two routers 2811's one with a DS3 and the other with an ethernet feed from two different providers. I am running BGP for the providers and IBGP between routers. I haver very well balanced inbound traffic but I have 90+% of my traf...

Dear All,There are error messages flood with '%IP-4-DUPADDR: Duplicate address 10.10.10.3 on FastEthernet0/0, sourced by 0009.6b62.1676'. The Duplicate ip address 10.10.10.3 is the virtual ip address of RouterA, could you please advise why the error ...

"""Hi; After I erased my flash i reboot the Router 2611 and tried to Install new IOS from Xmodem (Console) and when I changed the Baud Rate to 115200 and restarted . Hyper Terminal does not display any thing ...Urgent"""

I have a cisco 3745 router that supports the whole WAN,it has four E1 cards and a number of ethernet modules,It has been working OK till this morning when it failed to boot this is the error that i get:Cisco IOS Software, 3700 Software (C3745-ENTSERV...

I have a remote site customer with a C3750-48PS-S using an SFP, normally used as Gig. If they get part number GLC-GE-100FX will it work? What they would like to do is connect a 3750 to C2955C-12. Is this doable?

I have an mGRE tunnel configured between 6504 switches ( running IOS12.2(18)SXF7). The two switchs are at remote sites with an IPSec tunnel connecting the 2 sites.My issue is that I am seeing Output drops on the Tunnel interface, which is usually as...

Hello,I have a C877 (running c870-advipservicesk9-mz.124-15.T4.bin)and have established a DSL connection and on top of it an IPSEC tunnel.Everything is working fine in terms of IP connectivity. Additionally, I've configured LLQ and applied it under t...

Hi,I've two sites connect with cisco 878 (sdsl) in bridging mode. At the main office site I have a ts cluster with a virtual mac adres with ip 10.0.5.30. Here I can connect to this IP. At the remote site I can connect to each ts server but not to the...

I am trying to replacing the following static route:ip route 75.32.90.128 255.255.255.128 10.1.0.3Here is how I tried to configure EIGRProuter eigrp 100 redistribute static network 10.1.0.0 0.0.255.255 network 69.0.0.0 network 75.0.0.0 network 192.16...

Hi, I have the following topology in my lab setup. |PC-1| - |DUT A| - |DUT B| - |PC-2| I have redundant links between DUT A and DUT B(not shown in the diagram). Following is the config.----------------------DUT A Configuration==============...