Routing

HI, I have a router connected to an ISP over a serial interface using HDLC protocol. Every day the traffic stop going to ISP then i reboot the router and the traffic work again.I have tried to clear arp cache but it did not get back, only if i reboot...

Hello all, Can someone please take the pain to lead me into the step by step of how to connect a router to the internet.I currently have an ADSL internet connection.My routers are primarily 2611XM loaded with 256MB/32Flash, also have 2 CAT 3...

I am needing an example of a router config on how to set the 802.1p p bit to 5 for H323 traffic and all other traffic to 4 on a cisco router.

I am having a cisco 2811 router with one inteface (Fastethernet 0/0) connected to the lan and is also the gateway and other interface is FE 0/1 is connected to a Wireless Radio which have a bandwidth of 15 Mbps to a office near by which also have the...

One of our clients have two 6509E core switches. These switches are connected to a 3620 WAN router via a Layer 2 switch.The vlan thar makes this connection is Vlan2. EIGRP is the routing protocol. In the rouitng protocol configuration, i have passiv...

dear all,how we can login to the console without asking usrname & password when aaa new model is enabled

Does somebody knows how do I can get the configuration the router came with?I cannot use the SDM now cause something in the configuration file is missed.

I guys, i have the problem with configuration stack switch 3750, i can't find ios c3750-ipservicesk9-mz.122-25.SEB4.tar I ask if is possible that someone can send it to me ?

Hi,Is this version of IOS for my platform is comptatible with ipv6? Or do I need to upgrade?Thanks

hello anybody know how to make a gibabit hand off from telco clocking at 100mbps work on an lx gbic we get alink light but no connect.I guess is there an ios interface command set like delay or ? that may help resolve the issue between the hand-off...

I am trying to migrate the routing protocol in my network from Ripv2 to EIGRP. On my main router i run both protocols with redistribution as the following:router eigrp 24redistribute rip .......router rip redistribute eigrp 24 metric 2What the metric...

I have attached a diagram for the connection that I've made for my four routers. A and B were connected using serial ports via frame switch using smart cables. Now, I am short of serial cables for my third router C. I connect router C using cross RJ4...