Routing

How can these features be locked down so that someone connecting their router to your network doesn't automatically start communicating with your router and potentially start broadcasting your multicast traffic?Will enabling PIM and IGMP snooping do ...

I have a 805 router connected to a privated leasead line in the serial interface (hdlc protocol). I need Dial Backup for this serial link. This is possible with the console port?

Hi,We have a test network that is partitioned off the production network via a routed connection and ACLs. But a VNC session needs to be allowed from the test network to production network AND from production to test network.The ACL will have to be '...

Hello, I have a policy map defined on a 3845 router running c3845-advipservicesk9-mz.124-3b.bin. Iam trying to configure the service policy under the PVC, but it does not reflect in the running config.PLease find the ATM PVC config below.interface AT...

One of our client require repeater solution.Hotspots include 6 rooms and one swimming pool need to be wifi enabled.Only one room has cable and the client do not want to do cabling.He wants a solution through repeater.One root AP supports how many rep...

Hello all,I am with problem that sometimes the comunication is lost, the lik was working propelly but suddenly the comunication get down. When I access the router by console and I remove the virtual-template and change the ppp protocol for IETF, and ...

Dear sir,One of my customer is having cisco 2821 routers(rugged routers).1)MAIN LOCATION and 4 remote locations.In main location having 2 2821 routers and each remote location having one 2821 router.MAIN LOCATION:----Connectivity:---In main location ...

Hi,I have 2 Cisco 2821's. Each have 2 VWIC-2MFT-T1-D1 Dual T1 cards in them. I am trying to install a single interface HWIC-1FE card as a management interface. The cards light up but are not seen by the router. Is this configuration supported by this...

As you see from picture i have 2 AS connected to each other via 2 PLCs (Link1 and Link2 both 6Mbps).Flows from Net1 to|from Net5&Net6 and Net2 to|from Net5 are very high bandwith consuming. I want to useload sharing for traffic-Link 1 - Net1-Net5 Ne...

boot-start-markerboot-end-marker!memory-size iomem 25clock timezone gmt +2no aaa new-modelip subnet-zero!!!!ip flow-cache timeout active 1ip cef!!!!!!!username admin privilege 15 secret xxxxxxxxxxxxxxxxxxxxxxxxxxxx!!interface Loopback0!interface Ethe...

Hello,We have one downstream location connected on NSSA. OSPF neighborship between ABR and downstream router is getting flucutated. In "sh log" in ABR, i'm seeing the reason being "too many retransmissions"... %OSPF-5-ADJCHG: Process 10, Nbr x.x.x.x ...

Which are the case where we are using virtual MAC address? and when do we need to implement BIA MAC address?what are the conditions to use them in different place? or what are the benifits?