Routing

Hello,I am trying to set up community based filtering and I cannot seem to be able to tag our own routes with community.Configuration is:router bgp 65000 bgp router-id 10.0.0.1 bgp log-neighbor-changes neighbor 10.0.0.2 remote-as 65001 neighbor 192.1...

hello,I know i have done this before, but i am having challenges configuring multiple static routes on a router for failover purposes.I have a a branch network that with some specific branches being able to connect directly to our HQ out of the count...

We have a 1700 Router at our corporate location and have a Netopia at our branch. NetScreen boxes handle the VPN. (I had nothing to do with this part)We are currently using 120% of our T1 according to McCleod. I have been running PRTG Traffic Grap...

Hi all, I have an 871 and it is hosting 2 IP's, ending in .53 and .54. From time to time (seeming to be more recently) 1 of the IP's will stop responding from the outside. The other will continue to work properly. I was told that the router may b...

Hi, I've lost the username and passwords for my 877W router. I not worried about the configuration just need to be able to log back on to reset it factory defaults. How do I do this please ?Also do I have to take the flash out to get back to ronmon...

Hi.. How do I make the WLAN Access Point as CCX enabled? I have Cisco Aironet 1130 AG series & 1230 AG series AP's/Can some one help me out in doing the settings for ccx?

all is in the title.thks so much

Is there any settings that was configured earlier that make the router to auto reboot automatically, or the router is confirm faulty?

Anyone has any idea on what <Available Bandwidth 3 kilobits/sec> on the output below means.NGPHCIAMP003#sh int s1/0Serial1/0 is up, line protocol is up Hardware is M2T-T3+ pa Description: PHCWRIL04-1; (45M MTN) LINK TO NGWRIIAMP021_S8/1/0; Interne...

Hello Everyone,We have a router in one of our offices that has a T1 as it's primary Internet connection and is doing PAT using overloading (using the serial0/1/0 interface address). A new fractional T1 was installed in another serial (serial0/2/0 int...

Can someone pls. explain what this command do under OSPF processredistribute static metric 20 metric-type 1 subnets route-map static-filterdoes it have any relation to the below command? also with the access-list 1?route-map static-filter permit 20 m...

I just want to know if say I do a static route for a particular subnet say 167.x.x.0 255.255.255.240 192.x.x.1 does this mean that I dont need anymore to do a static route for individual hosts? say 167.x.x.3 255.255.255.255 192.x.x.1? I am confused, ...

Hi all,I want to set the clock of switch and I have typed clock set 12:00:00 4 Sep 2007 to do it..When I issue "show clock" command the time is match with the current time.4948A#sho clock12:01:21.427 UTC Tue Sep 4 2007But when I "show logging" ----ti...