Routing

Hello.I though traffic shapping was only "out" of the interface. In that case why the Cisco Ios is actually giving us the possibility of configuring it as "in" AND "out" under the interface configuration ? R1(config-map-class)#frame-relay cir ? <1-4...

Dear All,Can DS3 card can be configured on Switch 4503 .

hi can any one please advice me how to configure a cisco 1841 router with ADSL port , i dont find any articles related to it,I have ADSL internet , can anyone please send me articles or advice regarding this, thanks in advance

Hi Friends,LAPTOP <---->RAS(AS5400)<---->LNS(10K)I have Windows XP on my Laptop and trying to establish PPPoE tunnel (using broadband adaptor of Win XP) between Laptop and RAS. Then RAS should initiate L2TP tunnel to LNS.Problem is:- I am able to fo...

dear,General failure: Why this happenes and from where this error comes from?Reply from 87.248.113.14: bytes=32 time=102ms TTL=48General failure.Reply from 87.248.113.14: bytes=32 time=103ms TTL=48Reply from 87.248.113.14: bytes=32 time=102ms TTL=48R...

Hello All,R1<----------->R2Currently i have a E1 circuit between R1 and R2 Routers.I am purchasing a new E1 circuit for Load Sharing with High availaibility.I wish to Bundle the both the E1 Circuits as Single Virtual Link.Please help me with the Samp...

Hi Experts,We have a 2610xm router which is no longer booting up and erroring"Unexpected exception to CPU vector".I tried to install a fresh copy of IOS from ROMMON using XMODEM, but it errors saying that there is not enough free space in the flash.P...

I currently have a setup where a router needs to route http and https to an ip address and 50, 51,and 500 to another ip, but they are the same ip (don't ask). Is it possible to specify ports when routing traffic?

Hi all,I am getting the following message about once every 30 seconds:09-18-2007 14:12:03 Syslog.Warning 10.2.3.254 145322: Sep 18 19:12:39.339: %FW-4-TCP_OoO_SEG: Dropping TCP Segment: seq:357141655 1500 bytes is out-of-order; expected seq:357116835...

I have a 2811 router running advanced ip services and I can't connect to the outside interface using SSH or TELNET. I am NAT'ing all my outbound traffic at that interface if i turn off NAT i can connect. Any ideas?

Hello,Does anybody know what following log message is related to?"Failed to start Kadis. Status -10"Appears shortly after bootup, once. 7204VXR/NPE-2G with EIGRP, BFD, some QoSThanks,Alex