Routing

do Service-Engine interfaces support CDP? I have mine connected to a 3560, but no CDP information is displayed on either side.

I have a router with an ip address and a secondary ip. In that interfaces there is a helper-adress to redirec de broadcast to dhcp server. Is any way to redirec only broacast from de primary interface ip address? thanks Marcelo

Hi, We have just installed a cisco 6500 and are trying to get our policing working for customers. The DSCP values seem to be getting lost. I have turned on "mls trust dscp" on the links to the core. We are also running MPLS on the core. Would this ...

I have a WS-C3750G-12S-S switch which is used as a backup for critical switches that have multiple fibre links. In the event the primary fibre link to the 6500 fails, the data will pass through this 3750 to the 6500 at our 2nd site until the link is ...

IOS newbie here trying to pat inside hosts to the address on e1/0.I'm sure there's not much to it, any help would be great. Thanks everyone.

I am trying to find an IOS release for a 2811 router that support an HWIC-1FE interface card, and also supports STUN commands. For some reason STUN isn't supported in the newer 12.4 IOS's that do support the HWIC. Is STUN no longer being supported at...

Hi all, got a couple (not stacked, completely independent) WS-C3750G-48TS w. SMI which are behaving oddly. Both were doing Lots of the following: 43ws1d: % COMMON_FIBb-4-DISABLIeNG: Commoni CEF is bening disablged due to a fatal erdror.43w1id: %COMM...

Hai all,I would like to know is there any option for Perpacket load sharing in 12000 series GSR Router

Hi All,I am having an issue with a WAN link I have across my MPLS. When I ping across the wan from edge to edge I am getting upwards of 600ms. When I am on the suspect router at the suspect site and I ping the ip of the local serial interface it go...

Hi GuysToday my Cisco router reboots automatically .I searched allot but did not found any reason.Following is the msg in sh version.When the router reboot no one was login to the router.System returned to ROM by abort at PC 0xBFC01ED0My config regis...

See attached:

Hi All,I've got this problem.First let me post my acc-list.access-list 101 remark ====== OUTSIDE INTERFACE ACL =====access-list 101 deny ip 192.168.0.0 0.0.255.255 any logaccess-list 101 deny ip 172.16.0.0 0.15.255.255 any logaccess-list 101 deny...

i have many discard error when i monitor my routers by solar wins1) please expain what is this error?2) how can i solve this issue?

I have an Internet Router with 4 seriel Interface, each of them connected to an E1. The first 2 ports have been Multilinked and is working fine. However when I tried to Multilink the other 2 lines as a second Multilink, I could not do it. The ISP say...