Routing

I have router Cisco 1841 on which I have two internet links. I have configured following two commands on it:ip nat inside source list 101 interface FastEthernet0/0 overloadip nat inside source static 192.168.172.17 interface FastEthernet0/0I want to ...

As you can see, i am a novice in cisco routers.How do i get the router back to it org. state. Where I can use SDM on ip 10.10.10.1. I ran the config-register 0x2102 From Doc.ID=46509. But where do i go from here.

hi ,I want to buy 2600 or 2800 cisco route and E1 ATM module (card) but the problem is how can I know that this module will be compatible with router IOS and does it support this module or not ?than you for your help ..

iam having 2900 xl switch in this all the lights r glowing and iam not able to go through the console how can i trobleshoot.plz help me

what is modular and fixed router? what is the main difference?

Dear Expert,recently i was configure the policy base routing on router, but over the interface i had put in "ip verify unicast reverse path", when put in this command over the serial interface, the traffic will drop. does anyone facing this problem b...

I have a site with 3 connections to a remote network, i learn a network via three routes, atm, les circuit and MPLS. Both the ATM and Les circuit are ospf learned routes all in area 0, the MPLS route for the subnet in question is via ebgp then redist...

Hi,we would like to implement the burst setting on Fast ethernet. e.g.normal: 10Mburst: 3Mdo we use the "rate limited" to do it? please adviseBest regards

Hi,I have a Cisco 837 ADSL router. I would like to find out if my 837 router is able to support 6M ADSL connection. Any response would be appreciated.

I am trying to migrate from RIP to EIGRP the network. I am using in all netwok 10.x.x.x . Shall i advertise in each router the interfaces with 10.0.0.0 or write exactly the network using also wildmask. What't the difference. Of course using 10.0.0.0 ...

Hi.Company plans to increase number of remote branches from 10 to 50. So, 2851 wouldn't be enough to perform simultaneous encryption, QoS and routing.Now I use such schemeProvider's net--L2 SWITCH--Eth Trunk--My2851--ASA---LANEach remote branch enter...