Routing

Hi,We would like to config following:1. setup tunnel in between R1 and R22. R1 is "ip nat inside" and R2 is "ip nat oustde" 3. I would like all users to access "66.221.132.2" this server, it must go to tunnel and through R2, R3 to outside internet to...

Hi,We enable the VPN and NAT on the same route. we would like following:1. 192.168.16.0/24 can NAT to outside internet (using x.x.x.x overload)2. 192.168.16.0/24 can access 192.168.32.0/24 to TW office via VPNdetail please refer the config file. The ...

All,I'm new to working with Cisco routers but enjoy a challenge. I'd appreciate any help that is possible. I've got two vlans on the router, one for the office network and one for a machine control network out in the shop. I have a separate connec...

I haven't been able to access our router using the Security Device manager (SDM) from Cisco. Not sure how to create a new vpn user and add the proper access and password. We already have a vpn group setup. thanks in advance.

Hi,Is this normal behaviour when I have a GRE tunnel between PE and CPE? When I tried to icmp from PE to CPE tunnel address I got the following output in CPE and the ping fails.Jul 4 16:52:57: Tunnel1: adjacency fixup, 10.36.73.1->10.36.85.156, tos=...

We recently added a 2851 router to our network. It connects to a 3750 switch via a MOE circuit. The link is up just fine (interface up, line protocol up), we can ping or telnet to anywhere in our network from the 2851, but we cannot pass any higher...

We have an application base on SQL, this application is provided by server throught a private WAN link with maximun capacity of 2Mbps current usages is 800Kbps. We are experimenting problem with application time out and we have solved it adjusting th...

Looking for some advise.We are using a new product form Time Warner Telecom. It provides WAN access and Internet traffic off of the same inbound dta circuit through the use of a VLAN for the Internet traffic.I have the WAN setup and INternet working...

Hi all,I have the following escenario:Main router is configured with Traffic Shapping, there is branch routers with VoIP configure, other no. The routers that has VoIp configure work fine, but the routers that doens't has VoIP, has traffic problem wi...

Hi, HOw can upload IOS into a stack of 3750 switches using the archive download command? I cannot find the .TAR file.Please helpCheers

Hi,E2(branch)E0-----(VPN tunnel)-----E0/0(HeadOffice)E0/1i wanted to prioritize the mail server (residing at head office)192.168.0.35so i setup a Low latency Priority que (percentage based) at the branch's router cisco837. i found the method at Cisco...