Routing

One of our customer has purchased over 500 Cisco 2811 routers about over a year ago. We seem to get one router H/W failure every 2 or 3 days - different ones at different sites. It is either fan or power supply or mother board. Anyone else has seen t...

hi knows someone if there exists a cisco glass fiber module (and which model ?) for the cisco 2610 router ?kind regardspiotr

Hello,There are 20 vlans on C4500, I would like to source route 3 vlan traffic to router2 and all other traffic to router1. C4510 is connected to ASA5510 inside interface.How can I achieve this ?

Hello,Currently, I'm using cat4000-i9s-mz.122-25.EWA7.bin image on C4510.Is C4510 capable of running Policy based routing ? If it's possible, Are there memory requirement to run PBR on C4510

Hi all,I have few questions about ISDN to clarify my thoughts.I have a ISDN line with 3 numbers. I live in Switzerland. I would like to use this line to connect two Cisco Routers with a ISDN line in London.If I want to use 128k for this ISDN line, wh...

Has anyone worked with V.11 interface.Pls provide the details.Regards

If you're comparing PIX or ASA with Security features on C2821 ISR, Are these security features on C2821 ISR just as good as PIX or ASA ?Is it good enough to replace the PIX or ASA facing the internet ?

ASA 5510 10/100 interface doesnt get the IP address from DHCP server untill unless you hit the renew DHCP button. Has anyone ever come across a problem like this?

HiHow do i configure my router to act as a NTP server so that all my xp workstation are able to get the time from this ntp server. And also this ntp server will get the time from the external source. I have a cisco 1720 router with ADSL connection to...

Hi All,My 3821 DMVPN hub router has this configuration and the MTU may be higher than it should be.interface Tunnel0 description Tunnel for DMVPN bandwidth 4500 ip address 10.x.x.x 255.255.255.224 no ip redirects ip mtu 1416 no ip next-hop-self eigrp...

I have been trying to plug in the different metrics (bandwidth, delay, reliability, load, and mtu) into the EIGRP metric formula, but have been unsuccessful at figuring out how it comes up with the composite metric. Here is the info I havedefault me...