Routing

I have a 4Mbps Internet connectivty to a Tier-1 backbone ISP. Whenever I tried to stream video from CNN, Yahoo, etc, I only hear the audio while the video (picture) breaks (cracks). What can I do to ensure the video streams easily like the audio.

Hello All,I would like to know how the enterprise network looks like.I mean in sum of routers and switches, how many routers and switches enterprise networs usually has.Thanks Ahead,Boris Reuven.

anyone know what version of T1 WIC the 2800 series router supports?

Hello, using private AS numbers. RouterA is set for AS 1. I already have a neighbor to RouterB configured for remote AS 2 through a wan connection. I want to peer with RouterC through an ethernet connection but they are also using AS 2. Is this pos...

Hi,I would like to know the amount of overhead and throughput consumption that a site-to-site IPSec tunnel would create on WAN links, especially the ones with low throughputs like 128 kbps? So, in such link provided that the classification of my data...

We have 2 L2TPv3 Tunnels running between 2 PE's(7204VXR's with NPE400's) - We use these tunnels for our backup network traffic.Peak usage the backup system pushes ~ 12-15Mb/sec - This causes CPUs on both PE's to increase by ~35% - Is there anything t...

What is the RTO value on show ip eigrp neighbor?I have two wan link with same bandwidth. The RTO value for one link is 10 times higher than the other. Is it abnormal?Thanks.

How could I tell if SNMP traps are being sent for an atm interface?

In this post :SOURCE-IP@ = SOURCE IP@ of the GRE tunnel = INTERNET IP@ of the router GATEWAY-IP@ = next hop to internetDESTINATION-IP@ = DESTINATION IP@ of the GRE tunnel = INTERNET IP@ of the remote routerHi,I have 2 VRF on a cisco 2811 running a c2...

My ISP in NZ only support VC mux encapsulation for ADSL connection. Is there a VC MUX equivalent in 877W?

I have a Cisco 11500 series content switch. I have a website that has multiple websites that use the same IP address but use host header to differenciate between the sites. Can the content switch be configured to access a site by sitename (www1.xyz...

Hi all,I want to advertise loopback address with its subnet mask in ospf. One way is by making the loopback point-to-point.ex:RTA(config)#int lo0RTA(config-if)#ip ospf point-to-pointIs there any other way?

Trying to design a WAN to LAN connections. One of the part is to connect Cisco 7206VXR-NPE-G2 to Cisco 3845.One option is to use E1 connection (as WAN), using Mix-Enabled T1/E1 Port Adapter (PA-MCX-2TE1) at the 7206 and 1 port T1/E1 Voice/WAN (VWIC2-...

Hi guys,I have a PBX with an E1 link going to R1. R1 goes via ethernet to R2 which has an E1 going to the UK PSTN. (I haven't actually installed the routers yet).The questions:1. What kind of E1 cards to I require? I've seen both balanced and unbalan...