Routing

HI all,We are having an strange issue in a 7304 core router, the thing is that after adding a new route which overlaps another one already configured (an human error here) the route processor crash and an the box behavies in a very strange way, here...

Hi, can you help me with the basic thought below ?I have been assigned 132.45.0.0/16 network block.I need to establish 8 subnets.1) Assuming that the first subnet is the "0" subnet and the last one is the broadcast one, I would do2^n - 2 = 2^3 - 2 = ...

Hi all,If I subscribe a 100Mbps ATM circuit, does that mean that I have 100Mbps outgoing bandwidth and 100Mbps incoming bandwidth (full-duplex)? If So, I saturate my outgoing bandwidth, people have no problem sending traffic to me as the incoming ba...

Hi, i have got 1700 series internet router, gone threw several documents in cisco, was confused, so my requirement, i wanted to make use of 30% of HTTP traffic,50% of FTP traffic & rest traffic 20%, so any working configuration those who have alread...

I found a 2501 router with two serial interfaces and one eth (AUI). It has 4MB flash and 1024K of main memory. It's running IOS 10.2(6). I would like to use it for my CCNA labs. Any chance I could upgrade the IOS in it to something more reasonabl...

Is there any reason not to run CEF on a Border router (7206)? Will enabling CEF cause any side effects while router is in production?

i have a new t-1 i want to turn up using a VWIC-2MFT-T1 on both ends of the circuit. normally i would use a wic 1dsu t1 v2 on one end and a VWIC-2MFT-T1 on the other. i installed the VWIC-2MFT-T1 with the standard controller configuration (linecode b...

how to restart/start SNMP service in a router?

Hi all,I have a scenario with two wan connections. I want one for dialin vpdn (gre) and the other one for internet (the rest). I try to do a route map for routing gre traffic across Dialer1 interface but this not works.here is my config,ip local ...

Hello,Is the WS-SUP32-10GE-3B compatible with the older, non "E" versions of 6500 series switch?Thanks

hihow can i remove 2 port Ds3 card in running system (7206 VXR).is there any thing special ???plz let me know waoying for ur reply.thanks

Has anyone across this? How do you Fix? The router has been reloaded already but still does the same. Telnet works fine.Cisco 2811 Router - c2800nm-ipbase-mz.124-3f.bin.Is this an IOS bug or is it clogin?

Can Anyone Please provide the answers fr the following questionsThere are broadly 4 types of Telecom Services? Frame Relay (FR), Leased Line (LL), ISDN, POTS. Are they differing only in terms of Speed or Bandwidth? Why we have Origination and Termina...

I have customer we are installing 2 3560's, one at building a and one at building b. The buildings are connected with one Optical link and one 5.8GHz link. The 5.8GHz link will plug into one of the 10/100 port and the optical will plug into port 1 F...

1. Does cisco 1811 router supports WAN Failover?2. How will I configure it & also the config of load balancing?