Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Labels

Forum Posts

hi all.........today i got a v tough interview i have 4 years of experience in wan and configuring cisco devices but i was totally stuck today as i didnt give any answer to MPLS section......plz can someone help me out...i want to know this tech inan...

Hello,We recently implemented a hosted NVPN solution in which each site has a T1 to the carrier, who manages the routing between sites. In a sense it's like a fully-meshed frame-relay, except it's ATM and we get an ethernet handoff. The problem is ...

agaskill by Level 1
  • 989 Views
  • 3 replies
  • 0 Helpful votes

We been seeing tons of Line Code Violations and Path Code Violations on our T1 (frame relay). Telco has tested the circuit a few times, it's clean. Telco says we are getting hit with tons of traffic causing the Line Code Violations and Path Code Vi...

alex by Level 1
  • 29976 Views
  • 6 replies
  • 0 Helpful votes

Hello all,I will soon have the task of working on several routers at another company. The company has multiple sites connected by a variety of links. In particular, two sites are connected using a single T1 between a pair of 2611's. The company is in...

I've downlowded the new IOS relase 12.1(22)EA5 for Cisco2950 switch in order to support the full range of VLAN IDs as mentioned on Cisco sitehttp://www.cisco.com/en/US/products/sw/iosswrel/ps5013/prod_bulletin0900aecd802efa1c.htmlAfter upgrading the ...

mahadhema by Level 1
  • 2986 Views
  • 2 replies
  • 0 Helpful votes

Hi I have a STM1 interface on my 6509 and the interface is multi mode. I want to connnect to the service provider transmission equipment but their equipment supports only STM1 on Single mode. Have you guys seen a situation where once side is Single m...

janith by Level 1
  • 384 Views
  • 1 replies
  • 0 Helpful votes

Hi.I have question, 1)does IPSec support Multicaste capability ?2)Why we configure IPsec tunnel into GRE tunnel ?I have read one cisco documents as per doc , IPSec does not support IP multicast , but when we use netscreen firewall ( end to end ) IPse...

In CCO docs much is made of EIGRP's ability to provide "sub-second" convergence via feasable successors. Are feasable successors required at both ends of a route in order for this to work? For example, if router A can get to D through B or C, and ...

mmorris11 by Level 4
  • 475 Views
  • 4 replies
  • 0 Helpful votes

HiHow do I tell my router to send traffic from a particular VLAN (146) out through a particular interface. The data from VLAN146 is replication data. At present it goes out through interface 8/0/0 I want it to go through interface 9/0/0 all other tr...

I have a few different router types and am confused about IOS releases. I'm using 2600 & 1700 series routers and both use a 12.x ios. Are the ios releases hardware dependent? Can anyone offer advice on keeping our ios up-to-date, but not on the bleed...

Hi allI am a newbie in BGP, although i know BGP therotically. I have some curious questions1. Can some BGP guru help to give a real life example in which a company will use BGP ?2. With regard to AS, can someone also help to eloborate a situation in ...

caijunjie by Level 1
  • 631 Views
  • 3 replies
  • 0 Helpful votes
Unanswered Topics